Xantech 28EXT, HDMI4X4 Connections, Table B, TIP IR Signal Sleeve Ground, TIP IR Signal OUT Ring

TABLE A (continued):
APPLICATION #5 – VERIZON® FiOS™ MOTOROLA® RECEIVERS
Model:	TIP	+5VDC Power
QIP7000 Series	RING	SIGNAL
Connector marking: IR RECEIVER INPUT	SLEEVE	GROUND
	Wire-Swap Connector Required

CONNECTIONS

•Connect the 28EXT output, using the Wire-Swap Connector if required, to the equipment’s IR input.

•Connect the 28EXT input to a Xantech IR system’s connecting block. The yellow plug should connect to the yellow connector (emitter connection).

TABLE B:

28EXT Input and Output Connector Pin Assignments:

INPUT – 3.5mm Mono Male

TIP IR SIGNAL IN

SLEEVE GROUND

OUTPUT – 3.5mm Stereo Male

TIP	IR SIGNAL OUT
RING	+5VDC Power
SLEEVE	GROUND

•Make sure the source unit is on and the Xantech connecting block and IR receiver are powered.

•Direct a remote control towards the IR receiver connected to the IR system and make sure the electronic equipment responds.

Limited Warranty

Xantech® warrants its products to be free of defects in materials or workmanship. This is a Limited Lifetime warranty from the date of purchase by the original consumer. Any products returned to Xantech and found to be defective by Xantech within the warranty period will be repaired or replaced, at Xantech’s option, at no charge. Xantech will not be responsible for the actual cost of installation or removal of the product, nor for any incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights. You may have additional legal rights that vary from state to state.

Xantech Corporation

13100 Telfair Ave. Sylmar CA 91342 Xantech.com

Installation Instructions, 28EXT © 2009 Xantech Corporation

Document # 08905197B

All registered trademarks and trademarks (SIRIUS, GEFEN, OMNIMOUNT, VERIZON, VERIZON FIOS, MOTOROLA, POLK AUDIO) are the property of their respective owners. All other marks are registered trademarks and trademarks of Xantech Corporation. All rights reserved.

This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior written

consent from Xantech Corporation. Xantech Corporation shall not be liable for operational, technical, or editorial

errors/omissions made in this document.