Genius TVB-S201 PRO service manual Removal and Replacement

Page 17

Service Manual

Chapter 4. Removal and Replacement

Picture

2.Remove screws

Remove the rubber protectors at the corners and take out the screws.

3.Open the case

Remove bottom cover.

4.Remove PCB from case

Remove the PCB by lifting it and pulling it slightly toward you, being careful not to damage the LED light.

Version 1.0

Page 16

Image 17

Contents TVB-S201 PRO Service ManualBlock Diagram Table of ContentsTesting Procedures INTRODUCTIONChapter 1. INTRODUCTION c. Block Diagrama. Hardware b. Softwarea. Testing flow chart Chapter 2. Testing ProceduresCheck Y301 X’TAL signal T Check U1 CLK signal T END A T Check X1 X’TAL signal T Check OSC signal TREPLACE X1,U22 REPLACE X2,U5,U1 REPLACE Y301,U301L34 PIN1 b. Check VCC +5VREG2.PIN c. Check REG2 Pin 2 SignalREG5 PIN2 d. Check REG5 Pin 2 SignalREG3 PIN2 e. Check REG3 Pin 2 SignalREG4 PIN2 f. Check REG4 Pin 2 SignalU22 PIN26 g. Check X1,U22 Pin 26 X’TAL SignalU1 PIN41 U5 PIN62 h. Check X2 Pin 3,U5 Pin 62,U1 Pin 41 OSC SignalC322 PIN1 i. Check Y301 X’TAL SignalU1 PIN58 U5 PIN66 j. Check U1 CLKSAA SignalU1 PIN136 k. Check U1 RAMCLK SignalChapter Troubleshooting GuideChapter 4. Removal and Replacement Parts list Chapter 6. ToolsDescription Parts number