9.0Control Port
RS232 - Pins 1,3,5 Note: Pin 2 must be disabled with jumper J9 removed (factory default)
Pin 1 - Ground Pin 3 - TX Pin 5 - RX
Contact Closure - Pins 1,2,4,6 Note: Pin 2 must be enable with jumper J9 on VTune
Pins 1,2: TV | Pins 1,4: Channel + | Pins 1,6: Channel - |
Pins 1,4,6: FM | Pins 1,2,4: Volume + | Pins 1,2,6: Volume - |
10.1 RS-232 Protocol
Baud Rate: 9600 8N1
Note: Protocol below is as of firmware version 1.00 New commands will be available on future revisions to give more discrete full featured commands. Check on the Aurora website for the latest firmware and RS232 command additions.
? IS A QUERY COMMAND | (Does not have to be Case Sensitive) |
! IS A COMMAND | (Does not have to be Case Sensitive) |
~ IS A RESPONSE | (ALL RESPONSES ARE CAPITALS) |
<CR> is 0D hex or 13 decimal
!KEY_LEFT<CR> | Left |
!KEY_RIGHT<CR> | Right |
!KEY_UP<CR> | Up arrow key |
!KEY_DOWN<CR> | Down arrow key |
!KEY_SEL<CR> | Select |
Channel Down | |
!KEY_CH+<CR> | Channel Up |
!KEY_LAST<CR> | Toggles between the last 2 channels selected |
!KEY_0<CR> | 0 |
!KEY_1<CR> | 1 |
!KEY_2<CR> | 2 |
!KEY_3<CR> | 3 |
!KEY_4<CR> | 4 |
!KEY_5<CR> | 5 |
!KEY_6<CR> | 6 |
!KEY_7<CR> | 7 |
!KEY_8<CR> | 8 |
!KEY_9<CR> | 9 |
!KEY_SET<CR> | Set button for presets |
!KEY_P1<CR> | Preset 1 |
!KEY_P2<CR> | Preset 2 |
!KEY_P3<CR> | Preset 3 |
!KEY_P4<CR> | Preset 4 |
!KEY_P5<CR> | Preset 5 |
!KEY_P6<CR> | Preset 6 |
!KEY_P7<CR> | Preset 7 |
!KEY_P8<CR> | Preset 8 |
!KEY_P9<CR> | Preset 9 |
!KEY_P10<CR> | Preset 10 |
!KEY_P11<CR> | Preset 11 |
!KEY_P12<CR> | Preset 12 |
!KEY_VOL+<CR> | Volume up |
Volume down | |
!KEY_MUTE<CR> | Volume mute |