Before After
~14" to 16"
13.554" (34.43 cm)
17.07" |
|
|
(43.36 cm) |
| Mounting |
| Horizontal | tabs flush on |
| the OUTSIDE | |
| support beam | |
| of sheetrock | |
|
|
FIG. 2 CB-TP17 Rough-In Box installation into a notched stud (showing before and after installation)
Use a block to secure the
Stud
Drywall/sheetrock 
Mounting tabs for NXD Wall Mount panel should be flush with the outside of the sheetrock
Inserted block bridges the gap between the
Knockouts should be located on the
Stud fastening holes
Rough-In Box can be fastened to both studs)
Use four #8
to the
Secure Beam to block
Depth depends on the thickness of the Drywall
Notched stud
FIG. 3 Screw locations for Rough-In Box attachment in a pre-wall installation
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s). |
| REV: B |
|
10/08
©2008 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com