ZeeVee Zv-100 manual Connect your Hdtv to coax cabling, Tuning in your Zv channel, Part D, Part E

Page 10

Part D:

Connect your HDTV to coax cabling

Follow this Get Going Guide until prompted to follow steps on your HDTV.

Begin Part D when you have been instructed to do so by the Zv Installation Wizard

1.Check to see what’s attached to the antenna input on your HDTV.

2.If there’s a coaxial cable from the wall connected to the HDTV’s antenna input, your HDTV is con- nected correctly and you can skip to Part E.

3.Otherwise, connect your HDTV as shown in the diagram below:

New A/V cables or HDMI cable, if not previously installed (not supplied)

Set-top box

To antenna input on HDTV

New coaxial cables (supplied)

New splitter (supplied)

Existing coaxlal cable

Part E:

Tuning in your Zv channel

Follow this Get Going Guide until prompted to follow steps on your HDTV.

Use your HDTV’s remote control to enter your Zv channel number, excluding the ".99" at the end, then wait a few moments to see if the HDTV tunes in Zv.

If not, enter the Zv channel number with ".1" at the end instead of ".99" (on some remotes the decimal point "." may be a dash "-"), wait a few moments.

If the HDTV still doesn't tune in Zv, enter the full Zv channel number including the ".99" at the end, wait a few moments.

This process helps many HDTVs auto-scan for a new channel. If the above doesn't work for your HDTV, you'll need to perform a full "channel scan" to add new channels to the HDTV. This can take 30-45 minutes. Consult your HDTV's owner's manual for help.

Important: when performing the channel scan, set your HDTV to scan cable channels, not over-the-air channels.

9

© 2008, ZeeVee, Inc. All rights reserved.

Image 10
Contents Get Going Guide What’s in the box? Important Safety InstructionsFCC Statement What’s about to happen ZvBox Operation Fundamental Technical ConceptsInstalling and setting up ZvBox takes roughly an hour Splitter Get Going Guide Prepare your in-home coax cable networkPart a If you are unsure which connection is the input toPart B Connect ZvBox to the computerLaptop users Part B Connect ZvBox to the computer Zv Installation WizardTo this Get Going Guide If the coaxial cable connection is unused Connect ZvBox to coax cablingPart C Cable Modem usersPart D Tuning in your Zv channelConnect your Hdtv to coax cabling Part ETroubleshooting Tip Part E Tuning in your Zv channelWay control Shortcut keys Using ZvRemoteMouse touchpad Launch Zv Media control Need more information?