Technicolor - Thomson DPL950-EN manual Subtitle, language, camera angle etc, Radio

Page 2

DPL950-EN last new 5/7/03 10:06 AM Page 3

Troubleshooting Tips

Subtitle, language, camera angle etc.

Disc menu operation and contents may differ from disc to disc. Please refer to the instructions accompanying the disc.

There are no subtitles ?

Check that the subtitle is recorded on the disc.

Subtitles disappear from the TV screen. See page 21 to display subtitles.

Subtitle (or language) setting cannot be changed ?

The disc being played has been recorded in only one language.

Depending on the type of DVD, some segments limit language selection.

The picture is not displayed in the correct format on the TV (4 x 3 or 16 x 9)

According to your TV, make the correct "TV Screen" setting in the set-up menu (page 29).

The camera angle cannot be changed with the angle button ?

This function does not work when a DVD has not been recorded with a multi-camera angle system. Some DVDs use a multi-camera angle system only in certain portions of the DVD.

The menu language is not the one you want ?

The menu language for your player has not been set dur- ing set-up.

Your preferred menu language on a DVD disc (if available) has not been set during set up.

Audio (spoken) and / or subtitle language is not the one selected during the initial player set-up ?

If the audio or subtitle language is not available on the DVD disc, the language selected during initial player set-up will not be heard or seen. The disc's priority language (default language) is selected automatically. If you want another language, press menu during playback, if the disc has its own language selection menu (Refer to page 21).

Radio

STEREO indicator is off.

• Adjust the antenna.

The signal is Mono. Severe hum or noise.

• The signal is too weak. Connect an external antenna.

Equipment Specifications:

EN

AMPLIFIER SECTION:

Stereo mode: each 65W at 8 ohm. 10% THD @1 kHz

Subwoofer channel: 125w at 4

Muting Attenuation: 65dB

Frequency Response: 20Hz to 20kHz +/-1dB

Signal to Noise Ratio: 65dB (Bypass mode)

VIDEO SECTION:

Input ( Sensitivity/ Impedance ):1Vp-p/ 75ohm

Output (Level/ Impedance): 1Vp-p/ 75 ohm

Frequency Response: 10Hz to 6MHz at +/- 3dB

Signal to noise ratio: 40dB

Crosstalk @3.58MHz: 40dB

AM TUNER SECTION:

Frequency Response: 80Hz – 2kHz +/-6dB

Usable Sensitivity: 5000uV/m @ S/N 20dB

Signal to Noise: 30dB

Image Ratio: 20dB @ 1000kHz

IF Rejection: 35dB

FM TUNER SECTION:

Frequency Response: 40Hz – 15kHz +/-3dB

Quieting: 24dBu

Signal to Noise: 60dB(stereo) / 65dB(mono)

Image Ratio: 40dB

IF Rejection: 50dB

Dimensions (H x W x D mm) :

Unit - 60 x 431 x 355

Speaker - 134 x 88 x 104

Subwoofer - 363 x 236 x 289

41

Image 2
Contents Remote control Troubleshooting TipsPower Video and audioRadio Equipment SpecificationsSubtitle, language, camera angle etc Important battery information CleaningCleaning discs Safety precautionsTV functions Switch the key to tv position to control the TVRemote Codes VCR/SAT functionsUniversal remote control Programming TV Functions VCR/SAT receiver DVD or CD unitLanguage Codes