PREPARATION FOR USE
ANTENNA/CABLE CONNECTION
NOTE
•Cables used here are commercially available.
•For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.
- ANTENNA/CABLE CONNECTION
[Rear of this unit]
from Cable Company or Satellite Antennna
RF Cable
ANT
IF YOU HAVE A JACK ON THE WALL
Connect the TV to the
IF YOU HAVE A WIRED CABLE
Connect the TV to the wired antenna cable.
NOTE
•Before plugging the antenna into the ANT. jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. jack of the unit.
Bent pin
Cable Plug
(Needs to be | (Straight pin) |
straightened) |
|
- CABLE/SATELLITE BOX CONNECTION
[Rear of this unit]
WHEN USING CABLE BOX/SATELLITE BOX
ANT
Cable Box
or Satellite Box
OUT IN
If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown above.
Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the remote control of this unit.
from Cable Company or Satellite Antenna
NOTE
For CATV system installer:
•This reminder is provided to call the CATV system installer’s attention to Article
- 10 - | EN |