Sylvania 6313CD, 6319CD, 6313CD 6319CD owner manual Preparation for USE, ANTENNA/CABLE Connections

Page 9

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

 

From Cable System or

Satellite Box or

Satellite Dish

 

Cable Box

IN

 

OUT

(Not supplied)

 

From

Cable System

75-ohm Coaxial

or

 

Cable (Not supplied)

 

VHF/UHF Antenna

Rod Antenna

(Not supplied)

(Supplied with 13” model only)

 

 

VHF Antenna

 

(Not supplied)

 

UHF Antenna

or

(Not supplied)

VHF/UHF or Combiner

(Not supplied)

ANT.

or

Flat twin-lead cable

 

VHF/UHF COMBINED ANTENNA

The VHF/UHF Rod Antenna (supplied with 13” model only) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the TV/VCR. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna to the ANT. termi- nal of the TV/VCR as shown in the diagram above. For the best reception, fully extend the VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)

NOTE:

Before plugging the Rod antenna into antenna termi- nal, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into antenna terminal.

VHF/UHF SEPARATE ANTENNAS

In some areas it will be necessary to use an outdoor antenna.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to your TV/VCR without a converter box. By using this connection you can:

1)Use the TV/VCR remote to select channels.

2)Program one or more unscrambled channels for Automatic Timer Recording.

NOTE: This unit will ONLY record and view the same channel.

Bent pin

Cable Plug

(Needs to be straightened)

(Straight pin)

NOTE:

The connection of an indoor antenna may not always give acceptable TV reception.

CABLE WITH CONVERTER/ DESCRAMBLER BOX OR SATELLITE BOX

If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown here.

By using this connection you can also record scram- bled channels. However, channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the TV/VCR Remote Control. Unattended timer record- ing is limited to one channel at a time.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connect- ed to the grounding system of the building as close to the point of cable entry as practical.

- 9 -

EN

9I03

Page 8 Page 10
Image 9
Page 8 Page 10
Contents 6313CD 6319CD Important Safeguards S2 8 9 8 a Location PrecautionsAvoid the Hazards Electrical Shock and Fire Important Copyright InformationIndice Table of ContentsSupplied Accessories FeaturesOperating Controls and Functions Remote ControlTV/VCR Front Panel TV/VCRRear View ANTENNA/CABLE Connections Preparation for USEExternal Input Mode SET UP for USEInstalling the Batteries Channel SET UP for First TimeManual Clock Setting Clock SET UP Auto / ManualTo Change Clock Setting To Select a Desired ChannelChannel SET UP Again Automatic Clock SettingDeleting or Adding Channel DAYLIGHT-SAVING Time To Cancel the DAYLIGHT-SAVING TimeSelecting the Language Added channel Light blueTV Operation Game ModeWatching a TV Program Picture ControlTo Cancel the Closed Caption System Chip SET UPWhen the Closed Caption Mode is on TV Rating SET UPWhen you select TV-Y7 Mpaa Rating SET UPWhen you select TV-PG, TV-14 or TV-MA Selection Rating Category ExplanationsPlayback Auto Repeat PlaybackNormal Playback Still Picture SearchPicture Search Zero ReturnPicture Controls RecordingSkipping Unwanted Scenes During Recording Normal RecordingTimer Recording Pushes Display Recording lengthChannel CH61 Tape Speed SP Timer Program Extension To Correct a ProgramTo set another program, repeat steps 2 to Hints for Automatic Timer Recording Wake UP TimerAuto Return To Cancel the Wake UP Timer Sleep TimerTo Cancel the Sleep Timer Copying a Video TapeMaintenance Special FeaturesOn Screen Display Real Time Tape CounterTroubleshooting Guide Problem Corrective ActionClosed Caption Problem Possible Remedy General Specifications SpecificationsElectrical Specifications Other SpecificationsBotones de volumen Volume X / Y Botón K Botón de la alimentación PowerFunción de seguimiento- Pulse los botones Ventanilla sensora del mando a distanciaBotón de grabación de un toque OTR Botón BIndicador de grabación Record Compartimiento del videocasetePara Grabar UN Canal CODIFICADO/DESCODIFICADO Conexiones DE ANTENA/CABLEAutopreseleccion NotasRepetición DE LA Preparación DE Canales Duration TelPlease do not Ship Your Unit to the Teterboro Address
Top Page Image Contents