FIRMWARE RENEWAL MODE
1.Turn the power on and press [SELECT] button on the remote control unit to put the TV/DVD/VCR into DVD mode. Then remove the disc on the tray. (It is possible to move to F/W version up mode only when the TV/DVD/VCR is in DVD mode with the tray open.)
2.To put the TV/DVD/VCR into F/W version up mode, press [9], [8], [7], [6], and [MODE] buttons on the remote control unit in that order.
Fig. a appears on the screen.
"*******" differs depending on the models.
F/W Version Up Mode | Model No : ******* |
| VERSION : *.** |
Please insert a DISC for F/W Version Up.
EXIT: SELECT
Fig. a Version Up Mode Screen
The TV/DVD/VCR can also enter the version up mode with the tray open. In this case, Fig. a will be shown on the screen while the tray is open.
3.Load the disc for version up.
4.The TV/DVD/VCR enters the F/W version up mode automatically. Fig. b appears on the screen. If you enter the F/W for different models, “Disc Error” will appear on the screen, then the tray will open automatically.
|
| "*******" differs depending on the models. | |
| F/W Version Up Mode | Model No : ******* | |
|
|
| VERSION : *.** |
|
| VERSION : | ************.ab7 |
(*1) |
| Reading... |
|
|
| ||
Fig. b Programming Mode Screen
The appearance shown in (*1) of Fig. b is described as follows:
No. | Appearance | State |
|
|
|
|
|
|
1 | Reading... | Sending files into the memory |
|
|
|
2 | Erasing... | Erasing previous version data |
|
|
|
3 | Programming... | Writing new version data |
|
|
|
5.After programming is finished, the tray opens automatically. Fig. c appears on the screen and the checksum will be shown in (*2) of Fig. c.
|
| "*******" differs depending on the models. | |
| F/W Version Up Mode | Model No : ******* | |
|
|
| VERSION : *.** |
|
| VERSION : | ************.ab7 |
|
| Completed |
|
(*2) |
| SUM : 7ABC |
|
|
| ||
Fig. c Completed Program Mode Screen
At this time, no button is available.
6.Remove the disc on the tray.
7.Press [SELECT] button on the remote control unit to go to TV mode, or press
8.Press [SELECT] button on the remote control unit to put the TV/DVD/VCR into DVD mode again.
9.Press [1], [2], [3], [4], and [DISPLAY] buttons on the remote control unit in that order.
Fig. d appears on the screen.
"*******" differs depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : CLEAR EXIT: SELECT
Fig. d
10.Press [CLEAR] button on the remote control unit. Fig. e appears on the screen.
"*******" differs depending on the models.
MODEL : *******
Version : *.**
Region : *
EEPROM CLEAR : OK
EEPROM CLEAR : CLEAR EXIT: SELECT
Fig. e
When “OK” appears on the screen, the factory default will be set. Then the firmware renewal mode is complete.
11.To exit this mode, press [CH. o / p] or [SELECT] button to go to TV mode, or press
T1202FW |