Black Box ServShield, RM475, RM399 Front Door Filter RM476, Replacing a Rear Door Fan Filter

Page 14

Chapter 4: Operation

Fan Assembly

Fan Grill (3)

(RF207)

 

Rear Door

Fan Filter Cover

#8-32 x 34" self-drilling and tapping screws (12)

Figure 4-1. Replacing a Rear Door Fan Filter.

4.4 Front Door Filter (RM476)

You can easily remove the filter on the front door to clean or replace it. The part number for the front door filter is RM476. To remove the filter, remove the two wing nuts on the top of the filter, swing the filter bracket down and remove the filter. See Figure 4-2.

The life of the filter depends on the environment the ServShield is installed in. You can vacuum the filters or wash them in warm water with mild detergent. We recommend vacuuming the filter to keep it in peak condition. If you choose to wash the filter, do so only once and replace it with a new filter when it gets dirty again.

Page 14

724-746-5500 blackbox.com

Image 14
Contents ServShield Trademarks Used in this Manual Trademarks Used in this ManualFCC and RFI Statements NOM Statement Table of Contents Safety Considerations Preface/Safety Symbols Used in This ManualSafety Symbols Used in this Manual PrefaceShelf RM399 SpecificationsSpecifications 1.1 ServShield Fan RF207Front dimensions ServShield SizeSide dimensions Overview Introduction Optional AccessoriesOverview What’s IncludedLoading Equipment InstallationPower Shelves Bonding Protective GroundingParts Not Bonded to Protective Earthing Terminal Operation Leveling the Cabinet Fan Assembly RF207 and Rear Door Fan Filter RM475Operation Removing the DoorsFront Door Filter RM476 Replacing a Rear Door Fan FilterReplacing the Front Door Filter Mounting Rails Mounting RailsService ServiceBlackbox.com Page Black Box Tech Support FREE! Live /7