Use, Network socket | BSS Audio 9014 specs

SoundwebTM

Use

The 9014 requires 12-24v DC to be supplied externally. There are two ways of getting power into the unit:

•Connect a 24v 1A DC power supply to the 2.4mm barrel connector. Up to nine more 9014s may be powered from the paralleled combicon connector.

•Connect a 12-24v DC power supply to the combicon connector.

A pair of 9014 Fibre Interface units are used to replace a standard category 5 Soundweb network cable. Each fibre cable will transfer 8 channels of digital audio plus control data.

To utilise the fibre system, each end of the fibre link requires one 9014 device. Each device is equipped with an RJ-45 Soundweb network cable jack into which the network cable is connected, and two snap-in SC type fibre connectors.

Two fibre cables are then required to connect between 9014 devices - this is to enable the bi-directional data transfer.

Network socket

This connects to either the Network Out socket or the Network In socket on another unit.

The connecting cable is CAT. 5 network cable, terminated with RJ45 connectors, with all 8 cores wired straight through.

Note that the twisted pairs in any CAT.5 network cable must be wired to the following pin pairs at each terminal:

1 (White-Orange) with 2 (Orange); 3 (White-Green) with 6 (Green); 4 (Blue) with 5 (White-Blue); 7 (White-Brown) with 8 (Brown)

Note:

Ensure that all Out sockets are connected to their correct In sockets at each end of every cable. Connecting In - In (or Out - Out) will result in improper operation of the network.

124