Sample System Diagram, Satellite, Receiver

Sample System Diagram

In this system, CATV or antenna channels are available on all TVs. In addition the following channel has been added: Channel 70 - Satellite receiver

Attach the IR emitter directly over the IR sensor.

	SATELLITE	Option:
	RECEIVER
		To connect the video and audio to a local

	Video/audio	monitor, use RCA type ‘Y’ adaptors and
		remove the ’Termination’ jumper.
	outputs

	!				Remove jumper for Hi-Z
	!				(See manual)
	POWER
OUTPUT	15VDC	AUDIO	AUDIO	VIDEO	IR
OUTPUT	600mA	L	R	VIDEO	REPEATER
		L	R		REPEATER

Programming Examples:

To program modulator to channel 67

pwr IR program

	TM
	TM
model 5515 digital modulator with ir output	pll frequency control
Press program button	pll frequency control
model 5515 digital modulator with ir output	pll frequency control

6times

pwr IR program

Wait for power LED (ready for next number.)

pwr IR program

Press program button 7 more times

pwr IR program

75ohmcoax
shieldedonlyUse	RG6 coax preferred
	RG6 coax preferred

DA550HHR

DA550BID

POWER OPTION:

The DA550 does not need to be powered from its wall transformer when connected to an Model 5515. It will be powered by the modulator through the coax connection.

CATV/Antenna

model 2100 IR interface wall plate

Model 2173 IR emitter repeats what the IR target ‘sees’ in the other room.

To more TVs		Model 2132
To more TVs		IR Target
		IR Target

Any or all TVs may have a model 2132 IR Target

Control the DVD, DSS or VCR from any room.

To program modulator to channel 120

pwr IR program

			TM
		model 5515 digital modulator with ir output	pll frequency control
Press program button
1 time
pwr	IR	program
		Wait for power LED
		(ready for next number.)
		pwr	IR program
Press program button
2 more times
pwr	IR	program
		Wait for power LED
		(ready for next number.)
		pwr	IR program
Press program button
10 more times
pwr	IR	program
		Installer’s responsibility: To meet FCC part 15, use only a

	(press 10 times to	coax panel with >76dB modulator input to antenna input
	(press 10 times to	isolation. Also, the modulated signal must measure no more
	enter a ‘zero’)	isolation. Also, the modulated signal must measure no more
	enter a ‘zero’)	than 15.56dBmV at any wall-plate. (Using ChannelPlus 3308
		than 15.56dBmV at any wall-plate. (Using ChannelPlus 3308
		or 8200 panels will insure compliance.)