Vizio XRU110 quick start Initial Setup Setup

Initial Setup

Setup Setup, cont.

Insert the battery to the battery compartment to activate the remote control.

Battery replacement

Insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the battery with the (+) and (-) symbols inside the battery compartment. Re-attach the battery cover.

Precautionary Tips for Inserting the Battery

•Only use AAA batteries

•Inserting the battery incorrectly may result in cracking or leakage that may pose a fire risk or lead to personal injury.

•Dispose of the battery in accordance with local laws and regulations.

•Keep the battery away from children and pets.

Battery Saver

Your remote automatically turns off if the buttons are depressed more than 30 seconds.

Code Saver

You will have up to 10 minutes to change the battery in your remote without losing codes you have programmed. However, to avoid losing your codes, do not press any buttons until battery is installed in the remote.

Programming for TV, STB or DVD

Note: TV mode can be programmed for TV codes ONLY. STB and DVD mode can be programmed to control ANY kind of device listed in the code list. The remote is pre-programmed to operate VIZIO TVs under TV mode and VIZIO Blu-Ray Players under DVD mode.

1.Manually turn on your TV (STB or DVD).

2.Press the TV (STB or DVD) button and hold for 5 seconds until the LED flashes twice. LED will remain lit.

3.Find the programming code for your TV (STB or DVD) in the code list and enter it using the Number Buttons. The LED flashes once after entering each digit. If the code is accepted, the LED flashes twice after the last digit is and then turns off.

If the code is invalid, the LED will have a long blink and then turns off. Please repeat Steps 2 and 3 with the next code listed for the component and manufacturer.

4.Point the remote control at the TV (STB or DVD) and press the POWER button. The TV (STB or DVD) should turn off.

Note:

•If your TV (STB or DVD) does not respond, try all the codes for your brand. If the codes do not work, or your brand is not listed, see “Searching for Component Codes, page 13.”

•Sometimes a code listed will only include limited functions. Try other codes that may include more functionality.

Searching for Component Codes

If you cannot find the manufacturer in the compo- nent list or the program code does not work, you can use the remote control to search for the correct component code.

To search for a component code:

1.Manually turn on the component.

2.Press the matching component (TV, STB or DVD) button and hold for 5 seconds until the LED flashes twice. LED will remain lit.

3.Press 9 9 1 using the Number Buttons. The LED flashes twice after the last digit is entered and LED will remain lit.

4.Point the remote control at the component and then press the POWER button to start code search. LED will flashes every 3 second during

the search. Move your finger to the OK button.

6.After the component turns off, press the OK button within three seconds to save the code. If the component does not respond correctly, repeat the search procedure to find another code.

Reset Remote to Factory Settings:

1.Press and hold V button for 5 seconds until the LED flashes twice. LED will remain lit.

2.Press 9 1 9 1 9 using the Number Buttons. The LED flashes twice after the last digit is entered and then turns off. The remote is now reset to factory settings.

5 6 7 8