SECTION 3
ELECTRICAL ADJUSTMENTS
CD SECTION
Note:
1.CD Block basically constructed to operate without adjustment. Therefore, check each item in order given.
2.Use
3. Use the oscilloscope with more than 10 MΩ impedance.
4.Clean an objective lens by an applicator with neutral detergent when the signal level is low than specified value with the following checks.
Focus Bias Adjustment
Setting: This adjustment is performed with the set placed horizontally.
oscilloscope
SERVO board
TP (RF) 
+
TP (RF. GND) 
–
Procedure:
1.Connect an oscilloscope between TP (RF) and TP (RF. GND) on the SERVO board.
2.Connect the power supply.
3.Push the RESET button (S900) on the MAIN board.
4.Insert the disc
5.Adjust RV1 so that the oscilloscope waveform is clear and check RF signal level is correct or not.
Note: Clear RF signal waveform means that the sharp “
” can be clearly distinguished at the center of the waveform.
RF signal waveform
VOLT/DIV: 200 mV
TIME/DIV: 500 nS
level: 1.0 – 1.5
•When observing the eye pattern, set the oscilloscope to AC range and raise the vertical sensitivity so that it may be easily seen.
Adjustment Location: servo board
Focus Gain Adjustment (Coarse adjustment)
This adjustment is not required unless the following parts are replaced:
•Optical
•RV4
Procedure:
1.Set RV4 to the standard position. (mechanical center)
2.Check whether operation noise (while noise type) caused by the
If the operation noise is too loud, turn RV4 slightly counter-
clockwise.
•If the gain is too low:
Focus does not function and no music is selected.
•If the gain is too high:
Noise caused by scratches and dust is heard and the operation becomes unstable.
Adjustment Location: servo board
Adjustment Location: servo board (component side)
FOCUS GAIN ADJ
RV4
IC3
CN2
TP
IC1 | (RF. GND) | |
CN1 | ||
IC2 | ||
|
TP
(RF)
CN3
RV1
FOCUS BIAS ADJ
10