VIZIO E322VL User Manual
Audio Troubleshooting
| Issue | 
 | Solution | 
| 
 | 
 | ∙ Press Volume + (Up) on the remote control or side of the TV. | 
| 
 | 
 | ∙ Press MUTE on the remote control to make sure that MUTE is not ON. | 
| 
 | 
 | ∙ Check the MTS Audio settings in the Tuner menu to insure they are set to | 
| No audio | 
 | Stereo/English. ( TV input only ) | 
| 
 | 
 | ∙ Verify that the TV Speakers are On in the Audio menu. | 
| 
 | 
 | ∙ Check the video/device cable integrity. Try another cable (HDMI, | 
| 
 | 
 | AV/Composite, Coax etc.) | 
| 
 | 
 | ∙ Change audio settings of the external device. | 
| 
 | 
 | ∙ If you are using an antenna, the signal strength of the channel may be low. | 
| 
 | 
 | Make sure your antenna is connected securely to your HDTV and move the | 
| 
 | 
 | antenna to an alternate location in the room or close to a window. | 
| Audio volume differs on | 
 | Your HDTV will retain the last used volume level for each input. | 
| each input | 
 | 
 | 
| Low audio volume (TV | 
 | ∙ Press the Volume up on the remote control. | 
| internal speakers) | 
 | ∙ Increase the volume of the external device using that device’s remote. | 
| 
 | 
 | |
| 
 | 
 | 
 | 
| Distorted/popping audio | 
 | ∙ Check video/device cable integrity. Try another cable (HDMI, AV/Composite, | 
| 
 | 
 | Coax etc.) | 
| 
 | 
 | ∙ Insure audio cables are tightly inserted into inputs. | 
| 
 | 
 | ∙ Try another device. | 
| 
 | 
 | ∙ Use another device input. | 
| 
 | 
 | 
 | 
| Remote Control Troubleshooting | ||
| Issue | 
 | Solution | 
| 
 | 
 | ∙ Point the remote control directly at the remote sensor on your TV (IR mode | 
| The remote control will not | 
 | only). | 
| 
 | ∙ Remove any obstacles between the remote control and the remote sensor (IR | |
| work | 
 | |
| 
 | mode only). | |
| 
 | 
 | |
| 
 | 
 | ∙ Replace dead batteries with new ones. | 
| 
 | 
 | 
 | 
| The remote control will not | 
 | ∙ Check the Advanced Audio menu located in the HDTV Settings App. Audio | 
| adjust TV Volume. | 
 | control must be set to TV. | 
| Channel Up and Down | 
 | ∙ In the HDTV Settings App, select Tuner, then Auto Channel Scan. This must | 
| buttons will not work. | 
 | be performed before attempting to change channels. | 
44
www.VIZIO.com