Toshiba HD-XA2KN owner manual Before calling service personnel

Page 71

Chapter6Others

Before calling service personnel

If you experience any of the following difficulties while using this unit, check the list below before consulting your nearest Toshiba dealer.

 

Symptom

Remedy

 

 

 

 

 

 

No power.

. Is the power plug disconnected? Check the power connection.

 

 

 

 

 

 

 

 

No picture.

. Is the cable for connecting the player and TV disconnected or not connected properly?

 

 

 

 

 

Check the connections ( page 21 – 22)

 

 

 

. Switch the input of the connected TV to the signal from the player.

.Check the settings (MODE switch and “Resolution Setting”). ( page 24)

.Are both the HDMI OUTPUT jack and the COMPONENT OUTPUT jacks connected simultaneously? Select either connection and make the appropriate setting.

( page 21 – 23)

No sound.

. Is the audio cable disconnected? ( page 22)

.Is the volume of the device turned down to the minimum level? Check the volume.

.Switch the audio input of the device connected by the audio cable to the input from the player.

.Set “Digital Out SPDIF” or “Digital Out HDMI” ( page 55) properly in accordance with the connected device and connection procedure.

.The volume level is set to the minimum. Adjust the volume. ( page 56)

.Change the output resolution ( page 23) so that sound can be heard.

.If using the optical digital output for a Dolby Digital Plus, Dolby TrueHD, DTS-HD or DTS soundtrack, be sure your AV receiver or processor is set to use the input connected to your player and is set to output the respective sounds.

Output level of multi channel . Set “Speaker Setting” ( page 56) to “2ch”. sound is reduced.

Multi channel sound is not . Set “Speaker Setting” ( page 56) to “5.1ch”. output.

The disc does not play. . Make sure the disc type can be played with the player ( page 28).

.Is the disc dirty or scratched? Check or clean the disc. ( page 29)

.If the disc is a DVD-RW or DVD-R disc, fi nalize the disc before attempting to play it with the player.

.If the disc includes parent lock support, playback is restricted while the parent lock of the player is set. Cancel Parental Lock ( page 59) or change the restriction level.

Playback picture has noise. . If video from the player is watched via a video recorder or on a TV with a built-in video recorder, the copy guard may prevent images from being displayed properly. Be sure to connect the player directly to the TV.

 

 

The remote control does not

. Are the batteries of the remote control dead? Replace the batteries. ( page 16)

 

 

work.

. Make sure the remote control is within range and pointed in the correct direction.

 

 

 

 

 

 

 

 

 

Screen freezes and no

. Pressing ON/STANDBY button on the player for approximately ten seconds forces the

 

 

 

 

buttons work.

player to turn off. Turn the player off and then on again.

Introduction Connections

(Basic)

Playback

(Advanced)

Playback

connection

Internet

Others

 

71

Page 70 Page 72
Image 71
Page 70 Page 72
Contents HD DVD player May result in hazardous radiation exposure See service procedureThis HD DVD player employs a Laser System Location of the required label 24!.4.3!&%49 .3425#4/.3 Additional Safety Instructions Precautions Moisture condensation occurs during the following cases Do not use the unit when moisture condensation may occurFeatures Customer support AccessoriesCertain limitations Table of Contents 7Picture Others 7Audio 7Language 7Ethernet 7General 7Firmware updateChanging picture quality AdvancedFront panel Index to parts and controlsRear panel Display Return Remote controlClose the cover Preparation of the remote controlOpen the cover Insert batteries Brand code table While holdingRelease Programming for TV controlIcon Disc Hint on reading this manualIcons for function applicability Instructions and actual buttonsConnections Check the type of video input on your TV Connecting to a TVMode switch on the player Via Hdmi input Connect the player to your TVConnect either Via component video inputVia S-VIDEO or Video yellow input Setting of video output resolution of this player Configure settings for your displaySettings and actual output resolution Mode switch Output jacks on Resolution Setting PlayerMake the connection as below, and set Digital Out Hdmi Connecting to an audio systemVia Hdmi output Via digital audio outputAnalog audio input Make the connection as below, and set Speaker SettingVia 5.1ch analog audio output Playback Basic Disc Specification Disc compatibilityPre-recorded discs Recordable discs you can play on this playerOn storing discs On cleaning discsOn handling discs Press ON/STANDBY Powering on/Loading a discPress Front panel or Remote control PressIf playback does not start Stopping playback / Pausing playbackPlaying a disc To display aPlaying from the top menu Using A/B/C/D buttonsPress To select the title You want Press / / / to select the item you wantOn the TV screen Press while the audio setting is displayed on the TV screenSelecting the sound of a disc recorded in DVD VR mode During playback, pressWhile the angle number is displayed, press Multiple anglesSelecting the camera angle Skipping chapters or tracks Playing at various speedsLocating by entering elapsed time Press the number buttons toEnter a number of the section Locating by entering a section numberValue When complete, pressAdjusting picture quality Changing picture qualityAt page 37, select the number 1, 2 or Then press Selecting picture qualityPlayback Advanced Repeat modes are listed Press To select the repeat modeRepeat playback You can repeat a desired sectionMove the cursor Extension portsPress While a disc with Support for cursor use is playing Use the eight direction buttons toYou can confirm operational status and setting details Checking the current status and settingsInternet connection Connection requirement Internet connection feature OutlineBefore using Basic Playback Connection Connecting using a router e.g. Adsl5th Mac Address User information settingPreparation Insert the HD DVD disc and close the traySelect an item from the menu Page Others Returns to Customizing the function settingsPress / to select the setting item, then During stop, pressProgressive TV Picture Downmixed PCM AudioBitstream 2ch When you selected 5.1chCrossover Setting 1chLanguage Ethernet Select the desired limitation level by pressing / buttons GeneralSet the details Select On or Off by pressing / buttons. OnPress button to shift the cursor to the next input Auto Power OffTo set the clock of the player Select your time zone by / buttons, then press OKPersistent Storage Update Firmware updateInitialize Language code list PCM Output sound conversion tableGNU General Public License Version 2, June H i b i t aBasic Playback No Warranty GNU Lesser General Public License Version 2.1, February H i b i t BOthers Version ever published by the Free Software Foundation H i b i t D H i b i t CBefore calling service personnel Specification Playback Playback Internet Basic Advanced connection Others Rental Units Limited Ninety 90 Day Warranty on LaborLimited One 1 Year Warranty on Parts Your ResponsibilityHow to Obtain Warranty Services Disclaimer and Limitation of Remedy Limited Canadian Warranty For Toshiba Brand HD DVD PlayersLimited Warranty for Commercial Units Your ResponsibilityGeneral Provisions Arbitration and Dispute ResolutionHow to Obtain Warranty Services Memo Playback Playback Internet Basic Advanced connection Others Information on Customer Support
Top Page Image Contents