Replacing the connecting cable
Replace the connecting cable if it is damaged. To do so, please proceed as follows:
Remove the ear cushion. Grasp behind the ear cushion and pull it up and away from the earcup.
Loosen the screw and remove it.
Remove the cover from the earcup .
Pull the connector out of the socket. | ||
| Remove the antikink protection of the connecting cable | |
from the holding device . | ||
Insert the antikink protection of the new connecting cable | ||
| ||
| into the holding device. |
Plug the connector of the new connecting cable into the socket as shown in the diagram on the left.
Put the cover back onto the earcup .
Replace the screw and tighten it.
Slide the ear cushion onto the earcup.
Converting the headphones into a headset
If you wish to convert your headphones into a headset, please contact your Sennheiser service partner who will equip the headphones with a microphone.
8