Toshiba SD-5980SU owner manual Loading batteries, Operating with the remote control

Introduction

Identification of controls (continued)

Loading batteries

Open the battery compartment cover in the

1 direction of the arrow.

Operating with the remote control

Point the remote control at the remote sensor and press the buttons.

Within approx. 7 m (23 feet)

Install two “R03/AAA” batteries (supplied),

2 paying attention to the polarity diagram in the battery compartment.

3 Replace the compartment cover.

Caution:

• Never throw batteries into a fire.

Notes:

•Be sure to use AAA size batteries.

•Dispose of batteries in a designated disposal area.

•Attention should be drawn to the environmental aspects of battery disposal.

•Do not mix different battery types or combine used batteries with new ones.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones.

•If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to prevent battery acid from leaking into the battery compartment.

Distance: Approx. 7 m (23 feet) from the front of the remote sensor

Angle: Approx. 30° in each direction of the front of the remote sensor

*Do not expose the remote sensor of the DVD video player to a strong light source such as direct sunlight or other illumination. If you do so, you may not be able to operate the DVD video player via the remote control.

Notes on the remote control

•Direct the remote control at the remote sensor of the DVD video player.

•Do not drop or give the remote control a shock.

•Do not leave the remote control near an extremely hot or humid place.

•Do not spill water or put anything wet on the remote control.

•Do not disassemble the remote control.

•When using the remote control, press the button at intervals of about 1 second to ensure the correct mode of operation.

14

2F60201A [E] P10-14 14 2/22/05, 10:47 AM