Toshiba MD14F12, MD20F12 owner manual Inserting batteries, Operation

Introduction

Identification of controls (Continued)

Inserting batteries

1 Open the battery compart-	2 Install two “R03/AAA” batter-	3 Replace the compartment
ment cover in the direction of	ies (supplied), paying attention	cover.
the arrow.	to the polarity diagram in the
	battery compartment.

Operation

•Aim the remote control at the remote sensor and press control buttons to operate.

•Operate the remote control within 30° angle on either side of the remote sensor, up to a distance of approx. 5 meters.

Illustration of MD20F12

Approx. 5 meters

Caution:

Never throw batteries into a fire.

Notes:

•Be sure to use AAA size batteries.

•Dispose of batteries in a designated disposal area.

•Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accord- ance with applicable laws and regulations.

•If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new ones.

•When necessary to replace batteries in the remote control, always replace both batteries with new ones.

•Never mix battery types or use new and used batteries in combination.

•Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment.

12

5W30201A [E] (P08-12) 12 7/1/06, 3:56 PM