Toshiba 62CM9UA owner manual Important Safety Instructions, Installation

Page 3

Introduction

Important Safety Instructions

See “Important notes about your DLP™ projection TV” on page 8.

Be sure to observe the following instructions and precautions to ensure safe use of this TV.

Introduction

Installation

started

Always connect the power plug to an electrical outlet equipped with 220 – 240V AC 50 Hz.

Never use the TV outside the specified voltage range. It may cause a fire or an electric shock.

WARNING ABOUT THREE-WIRE GROUNDING-TYPE PLUG: Never remove the earthing pin on the power plug. This system is equipped with a three pin earthing-type power plug. This plug will only fit an earthing-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact an electrician to replace the wall outlet.

Never defeat the purpose of the earthing plug.

Check!

220-240V AC

About the fuse

In a three pin earthing-type, the fuse fitted in this plug is approved by ASTA or BSI to BS1362. It should only be replaced by a correctly rated and approved type and the fuse cover must be refitted.

Getting

Usingthe TV’sfeatures

Never insert or remove the power plug with wet hands. This may cause electric shock.

Never place the TV in an unstabilized location such as on a shaky table, incline or location subject to vibration.

The TV may drop or fall down which may cause injury or damage.

Never block or cover the slots and openings in the cabinet.

Never place the TV so that it is facing upwards, or on its side.

Never place the TV into a closet or bookshelf where the ventilation is poor.

Never spread a newspaper, tablecloth or curtain on the TV.

When installing the TV against a wall, always keep the TV at least 10 cm from the wall.

Never place the TV on a soft unstable surface, such as a carpet, or a

cushion.

The inside of this TV will overheat if the ventilation holes are covered, blocked, or sealed, which may result in a fire.

Never place the TV near a heater or in direct sunlight.

The surface of the cabinet or power cord may melt and result in fire or electric shock.

 

Viewingteletext

 

 

 

 

Equipment

connections

 

 

 

 

 

Referencesection

 

 

3

#01E03-08_6272CM9UAE

3

http://www.pureglare.com.au

05.10.18, 3:23 PM

 

Black

Toshiba 62/72CM9UA/E (E)

 

 

Image 3
Contents Introduction Getting started 62CM9UA 62CM9UE 72CM9UA 72CM9UEContents Important Safety Instructions InstallationSee Important notes about your DLP projection TV on Important Safety Instructions Gettingstarted UseNever repair, modify or disassemble the TV by yourself ServiceExemptions CleaningAbout insecticide spray Important informationImportant information Important notes about your DLP projection TVUsing the TV’s features Viewing teletext InstallationConnecting an antenna Installing the remote control batteriesExploring your new TV TV right sideTV front TV back view TV backWhen in TV mode Learning about the remote controlWhen in VCR or DVD mode Only for Toshiba VCR/DVD players When in Teletext modeSide panel Switching on the TVSwitching off the TV Turning the TV onLearning about the menu system Menu display chartSection Selecting a languageSystem selection, Auto tuning Manual tuningProgramming channel memory Do not Press ANY Other Buttons While Program sorting Programming channel memoryWatching TV programs Picture size selection To adjust the picture position Picture position, ResetPicture position adjustment Reset Picture position adjustmentTo adjust the basic picture quality Picture quality adjustmentPicture quality adjustment To select the picture modeViewing To activate the black stretchTo activate the Mpeg NR Noise Reduction To activate the DNR Digital Noise ReductionTo select the color temperature To use the cinema modeEffective signal and setup conditions To select the lamp mode Selecting the lamp modeSetting the MTS mode Sound adjustmentMTS Multi-channel TV Sound setting Selecting the Dual 1 or Dual 2 modeTo select the stereo programs Sound quality adjustmentTo adjust the sound quality Stereo/Bilingual selectionTo select the Hdmi audio mode To select the sound volume from Audio OUT terminalsTo select the audio output To use the WOW surround sound To use the Stable soundTo activate/deactivate the speaker To use the external woofer system To select the woofer Internal/External modeWoofer Internal/External mode, Bass boost, Woofer system To use the Bass boostTo select input source Manual settingInput source selection Input source selectionTo activate Blue screen Timer, Blue screen, Auto formatTimer To select the timer menuTo set the Quick restart Side panel adjustmentSetting the Quick restart feature To adjust the Side panel settingTeletext Setting up Teletext modeTo select Teletext mode Button Teletext SW adjustmentAbout Teletext Teletext general informationUsing Fast mode Using List modeTeletext Fast and List modes Teletext Control buttons Teletext buttons on the remote controlSide connections Connection exampleTV right side view Press here to open Using the TV’s features Teletext Back connectionsViewing Equipment Connections To connect a computer Connecting a computer PCSignal names for mini D-sub 15 pin connector Following signals can be displayedPC setting To adjust a PC settingTo adjust the Picture size/position To adjust the Clock phase of the picture To adjust the Sampling clockTo reset the PC Setting Standard analog audio cables To connect an Hdmi and a DVI deviceTo connect an Hdmi device To connect a DVI deviceTroubleshooting Symptom and solutionSymptom Solution LED indications LED Indication Condition SolutionYou should replace the lamp unit Lamp unit replacementWhen to replace the lamp unit Replacing the lamp unitHow to replace the lamp unit Lamp unit door detail TV backLamp unit door Broadcast system, Specifications SpecificationsBroadcast transmission systems of each country or region Component Video Input Using Viewing teletext Equipment ConnectionsToshiba Corporation
Related manuals
Manual 50 pages 11.57 Kb