Toshiba 42HP84 owner manual Appendix, Specifications

Page 63

Appendix

Specifications

This model complies with the below specifications.

Designs and specifications are subject to change without notice.

This model may not be compatible with features and/or specifications that may be added in the future.

WARNING: RISK OF ELECTRIC SHOCK !

Never attempt to service the TV yourself. Opening and removing the covers may expose you to dangerous voltage or other hazards. Refer all servicing to a Toshiba Authorized Service Center.

E

F

S

Introduction

 

Television System

NTSC standard

Channel Coverage VHF: 2 through 13 UHF: 14 through 69

Cable TV: Mid band (A-8 through A-1, A through I) Super band (J through W)

Hyper band (AA through ZZ, AAA, BBB) Ultra band (65 through 94, 100 through 125)

Power Source

120 V AC, 60 Hz (See page 7.)

Power Consumption

324 W (average)

Audio Power

10 W + 10 W

Speaker Type

Main : Four 2-1/45-1/8 inches (70 ⋅ 130 mm)

Tweeter : Two 1-1/4 inches (32 mm) round

Video/Audio Terminals

S-VIDEO INPUT

Y: 1 V(p-p), 75 ohms, negative sync.

C : 0.286 V(p-p) (burst signal), 75 ohms

VIDEO/AUDIO INPUT

VIDEO: 1 V(p-p), 75 ohms, negative sync.

AUDIO: 150 mV(rms) (30% modulation equivalent, 22k ohms or greater)

ColorStream¨ (component video) INPUT

Y: 1V(p-p), 75 ohms PR: 0.7 V(p-p), 75 ohms PB : 0.7 V(p-p), 75 ohms

AUDIO: 150 mV(rms), 22k ohms or greater

VIDEO/AUDIO OUTPUT

VIDEO: 1 V(p-p), 75 ohms, negative sync.

AUDIO: 150 mV(rms) (30% modulation equivalent, 2.2k ohms or less)

VARIABLE AUDIO OUTPUT

0Ð300 mV(rms) (30% modulation equivalent, 2.2k ohms or less)

HDMI INPUT:

HDMI compliant (type A connector) HDCP compliant

E-EDID* compliant

Suggested scan rates: 1080i, 480p, 480i, 720p

HDMI Audio: 2-channel PCM

32/44.1/48 kHz sampling frequency 16/20/24 bits per sample

HEADPHONE jack

3.5 mm stereo

TheaterLink

OUTPUT: 3 V(p-p), 10k ohm

Dimensions (Including TV stand)

Width : 50-5/32 inches (1,274 mm)

Height : 30-5/32 inches (766 mm)

Depth : 12-19/32 inches (320 mm)

Mass (weight)

xxx lbs (xxx kg)

Operating condition

Temperature: 32¡F Ð 95¡F (0¡C Ð 35¡C)

Humidity: 20 Ð 80% (no moisture condensation)

Connecting

yourTV

 

 

 

 

Usingthe

RemoteControl

 

 

 

 

Settingup

yourTV

 

 

 

 

UsingtheTVÕs

Features

 

 

 

 

Appendix

 

 

 

___________

*E-EDID = Enhanced-Extended Display Identification

63

Index

Image 63
Contents Introduction AppendixIndex Dear Customer Safety PrecautionsInstallation Important Safety InstructionsCare ServiceImportant notes about your Plasma TV Introduction Supplied accessories Introduction Connecting your TVWelcome to Toshiba OUT Exploring your new TVSettingup YourTV UsingtheTVÕs Features Appendix Index Connecting an antenna or cable TVConnecting YourTV Usingthe RemoteControlConnecting a cable converter box Connecting a VCRAppendix Index Connecting a cable converter box and VCRUnauthorized recording, use Connecting a DVD player or satellite receiver and a VCRFrom Antenna Stereo VCR From DTV Receiver with component video DTV Antenna You will need ¥ one set of standard A/V cables Connecting two VCRsConnecting a camcorder Connecting YourTV Usingthe RemoteControl¥ one pair of standard analog audio cables Connecting an HDMIª or a DVI device to the Hdmi input¥ one Hdmi cable type a connector ¥ one HDMIÐtoÐDVI adapter cable Hdmi type a connectorConnecting a device to the TheaterLink Connecting an audio system Installing the remote control batteries Preparing the remote control for useRemote Control functional key chart Using the Remote ControlCBL/SAT Audio VCR TV/VCR TV/SAT Searching and sampling the code of a device Device code setupOperational feature reset Using the volume lock featureDevice code table VCR setup codesCD Player setup codes Learning about the remote control Learning about the menu system Introduction Connecting YourTVUsingthe RemoteControl Settingup YourTV UsingtheTVÕs Features Appendix IndexPress y or z to highlight your desired language Setting up your TVChanging the on-screen display language Selecting the antenna inputAdding channels to the TVÕs memory Programming channels automaticallyPress Enter Press z to select CH Program Adding and erasing channels manually Changing channelsProgramming your favorite channels Adjusting the channel settingsSwitching between two channels using Channel Return Switching between two channels using SurfLockªPress Enter to display the Favorite CH menu TVÕsPress y or z to highlight Favorite CHPress Enter to erase the channel label Labeling channelsPress z or y to highlight ClearNatural picture size Selecting the picture size¥ None of the picture is hidden Setting Your UsingtheTVÕs FeaturesYour Up TV¥ To lower the picture, press z Press Enter to display the Scroll Adjustment modeScrolling the TheaterWide¨ picture TheaterWide 2 and 3 only ¥ To raise the picture, press yPress y or z to select ON, and then press Enter Using the Auto Aspect featurePress y or z to highlight Auto ASPECT, and then press EnterTo close the POP window Press Split again or Exit Using the POP double-window featureControl Switching the main and POP picturesSwitching the speaker audio main or POP UsingtheTVÕs FeaturesDouble-Window aspect ratio Using the programmed channel search functionAbout the auto favorite feature Using the favorite channel search functionEntering the PIN code Using the Locks menuUsing the V-CHIP menu UsingPress z or y to select an item Enable BlockingOFF To release your setting Unlock TV Rating Independent rating system for broadcastersMpaa Rating Mpaa Rating Independent rating system for moviesUnlocking programs temporarily Connecting Your Usingthe RemoteControlSetting your Locking channelsPress y or z to highlight Clear ALL, and then press Enter From the Locks menu, press y or z to highlight NEW PIN Code Locking the video inputsChanging the PIN code OFFPicture Settings Adjusting the pictureSelecting the picture mode Adjusting the picture qualitySelecting the color temperature Press x or to select the mode you preferSaving your new preferences Resetting picture adjustments Using the CableClearª DNR featurePress y or z to select Film auto Selecting the cinema modeSelecting the video input source Using the TVÕs FeaturesUsing the closed caption feature Press y or z to highlight Caption or TEXT, and then press¥ To view text, highlight T1, T2, T3, or T4 Setting the sleep timer Setting the on timerAdjusting the sound Muting the soundSelecting stereo/SAP broadcasts Using the WOWª surround sound feature Enjoying the Dolby Virtual sound featurePress y or z to adjust the item, then press Enter Resetting your audio adjustments Adjusting the sound qualityTo turn on the built-in speakers Using the StableSound¨ featureTo turn off the StableSound feature Select OFF in above Turning off the built-in speakersPress y or z to select Main or POP, and then press Enter Selecting the Audio OUT sound AUDIO/VIDEO OUT terminalsPicture shift Adjusting the long life featuresTime White pattern will be displayedDisplaying on-screen information Understanding the auto power off featureUnderstanding the last mode memory feature Selecting the background of the menu displayAppendix SpecificationsT2, T3, or T4. Turn closed captioning OFF TroubleshootingAntenna Black box appears on the screenLimited United States Warranty Limited Canada Warranty Index Toshiba ELECTROMEX, S.A. DE C.V