Connecting a VCR and satellite receiver

Chapter 2: Connecting your TV

From antenna

You will need:

one signal splitter

four coaxial cables

one set of component video cables (if your satellite receiver does not have component video, connect the standard A/V cables only)

one pair of standard audio cables

three sets of standard A/V cables

¥For better picture performance, if your satellite receiver and VCR have S-video, connect S-video cables (plus the audio cables) instead of the standard video cables. Do not connect both types of video cables to VIDEO 1 (or VIDEO 2) at the same time or the picture performance will be unacceptable.

¥If you have a mono VCR, connect L/MONO on the TV (VIDEO 1) to your VCRÕs audio out terminal using the white audio cable only.

To view satellite programs using the component video connections:

Select the ColorStream HD-1 video input source on the TV.*

To view satellite programs using the standard video connections or to record satellite programs:

Turn on all three devices. Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details). Select the VIDEO 2 video input source on the TV.*

To view the VCR or view and record antenna channels:

Turn ON the VCR. Tune the VCR to the channel you want to watch. Select the VIDEO 1 video input source on the TV.*

_____________

*To select the video input source, press INPUT on the remote control (see page 69). To program the TV remote control to operate other devices, see Chapter 3.

Signal splitter	IN
OUT	OUT

Stereo VCR

VIDEO	AUDIO
IN from ANT	L	R
CH 3		IN
CH 4
OUT to TV		OUT
		OUT
	L	R

TV back panel

From satellite dish

Satellite receiver

AUDIO

Y	PB	PR	L OUT L
Satellite
IN			R	R
S-VIDEO COMPONENT VIDEO			VIDEO
OUT			OUT

Note: The VIDEO/AUDIO OUT terminals output signals from the ANT 1, ANT 2, VIDEO 1, VIDEO 2, and VIDEO 3 terminals when the appropriate input mode is selected.

The unauthorized recording, use, distribution, or revision of television programs, videotapes, DVDs, and other materials is prohibited under the Copyright Laws of the United States and other countries, and may subject you to civil and criminal liability.

To use the TV Guide On Screenª recording features:

1.Connect the G-LINK™cable according to the instructions on page 26.

2.Make sure the VCR is connected to the A/V OUT terminals on the TV (see illustration).

3.Set the VCR to the appropriate line input (refer to your VCR owner’s manual for details), and then turn OFF the VCR.

4.See Chapter 5 for details on setting up the TV Guide On Screen™ system.

5.See Chapter 7 for details on using the TV Guide On Screen™ system.

Note: The TV Guide On Screenª system does not receive program listings from or for any satellite service.

16		Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
16
#01E_013-027_4250HP95	16	05.9.12, 10:05 PM
	Black

Toshiba 42HP95 Connecting a VCR and satellite receiver, From antenna, From satellite dish