Toshiba P42LHA owner manual Installation, For inquiries and repair

Page 15

Installation

To a service technician

For safety, make sure the place has enough strength to hold the whole weight of the monitor and the frames (*1). If necessary, reinforce the place before installation.

At least two people are needed for installation. Be careful not to lose removed screws or parts.

Before starting installation, discuss well with customers about the position to install, and get their agreement. After installation, check the installation is correct and safe.

*1: About the material and the structure of the wall, ceiling and floor to install LCD monitor Where to install the LCD monitor

If the wall is made of thin plywood or plastered board, it cannot hold the weight.

The chart below shows adaptable anchors for each material. Please check well the structure and strength of the place to install, and choose the best method for safety.

Adaptable anchors / screws for each material

Material

Anchor

Plastered board

Impossible to install in Plastered board or Plywood board. Install in the tie beam instead of the

Plywood board

wall.

Concrete

Whole anchor or Bolt

Block

 

ALC

Tie lock anchor

Mortar

 

Brick

Coach bolt (diameter: 6mm(0.236 inch) x length: 60mm(2.36inch))

Wooden pillar

For inquiries and repair

Please refer to the shop you bought the unit for repair and inquiries.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents LCD Monitor Contents Example of figure Safety InstructionsMay cause death or serious injury*1 May cause injury*2 or material damage*3If not, the unit may fall down and cause an injury Do not place objects on the unit Insert the power plug fully into a 100 － 240V AC outletFollow these precautions for the power cord and plug Do not place the unit in a location subject to vibrationInstallation Do not install the unit where humidity is high Do not insert objects inside the unitTake measures to prevent the unit from falling down Do not overload outlets or cables beyond their capacity Precautions for moving the unitNever insert or remove the power plug with wet hands Do not block the ventilation holes on the unitPrecautions for the remote control battery Consult your dealer for internal cleaning once a yearDo not push or jolt the LCD panel Features NTSC/PAL/PC SpecificationsBack Names and Functions of Controls UnitFront Side ControlsEffective range Names and Functions of Controls Remote controlBattery Installation About the remote controlPlease check all are supplied Supplied AccessoriesConnection Video Signal INPUT/OUTPUTFor inquiries and repair InstallationDimension Power On/Off Main power switchPower button on the remote control Menu Function Function of Remote controlVGA DVI Menu display chartDisplay Menu Main MenuColor Menu Position MenuOSD On Screen Display Control PIP ControlPage Input signal selection and its contents Guide to Simple Problem SolvingFactory default setting Symptom Check these thingsVGA Input SignalAbout trademarks Annex
Top Page Image Contents