Toshiba 55HT1U owner manual Selecting the picture size, Tuning to the next programmed channel

Chapter 6: Using the TV’s features

Tuning to the next programmed channel

To tune to the next programmed channel:

Press or on the remote control or TV control panel.

Note: This feature will not work unless you program channels into the TV’s channel memory ( page 24).

Tuning to a specific channel (programmed or unprogrammed)

Tuning analog channels:

Press the Channel Number (0–9) on the remote control. For example, to select channel 125, press 1, 2,

5, then .

Tuning digital channels:

Press the Channel Number (0–9) on the remote

control, followed by the dash () button and then the sub-channel number. For example, to select digital

channel 125-1, press 1, 2, 5, –, 1, then .

Note: If a digital channel is not programmed— either through the automatic channel scan ( page 25) or the Channel add function ( page 26)—you will have to tune the RF channel using

the Channel Number and dash () on the remote control.

Switching between two channels using Channel Return

The Channel Return feature allows you to switch between two channels without entering an actual channel number each time.

1無 Select the first channel you want to view.

2無 Select a second channel using the Channel Number buttons (and the dash () button if selecting a digital channel).

3無 Press on the remote control. The previous

channel will display. Each time you press , the TV will switch back and forth between the last two channels that were tuned.

Note: If you press from a non-antenna input, the TV will return to the last-viewed input.

Switching between two channels using SurfLock™

The SurfLock™ feature temporarily “memorizes” one

channel to the button, so you can return to that channel quickly from any other channel by pressing

. To memorize a channel to the button: 1無 Tune the TV to the channel you want to program

into the	button.
2無 Press and hold		for about 2 seconds until

the message “Memorized” appears on-screen. The channel has been programmed to the button.

3無 You can then change channels repeatedly, and

when you press	, the memorized channel
will be tuned.

The TV will return to the memorized channel one

time only. Once you press and then change

channels again, the CH RTN memory will be cleared and the button will function as Channel Return,

by switching back and forth between the last two channels that are tuned.This feature also works for external inputs.

Selecting the picture size

You can view many program formats in a variety of picture sizes—Natural, TheaterWide 1, TheaterWide

2, TheaterWide 3, Full, 4:3 HD, Native, and Dot by Dot (available in PC Mode Only).

Note: The “picture size” illustrations are examples only. The format of the image (in any of the picture sizes) will vary depending on the format of the signal you are currently watching. Select the picture size that displays the current program the way that looks best to you.

You can save separate picture size preferences for each input on your TV.

To select the picture size using the remote control:

1無 Press on the remote control.

2無 While the Picture Size screen is open, you can do one of the following to select the desired picture size:

•Repeatedly press .

•Press the corresponding Number button (0–6) while the Picture Size screen is open.

•Press  or  while the Picture Size screen is open.

(continued)

33