Toshiba CZ 19T31 manual Unblocking programs temporarily, Block Channel function, To block channels

Unblocking programs temporarily

1 If you try to watch a TV program that exceeds the rating limits you set, the TV will enter into the program block mode.

THIS PROGRAM HAS BEEN BLOCKED

TV–PG L V

EXCEEDS SET LIMITS

PUSH MUTE TO ENTER PIN

CABLE 4

2 If you want to watch the blocked program temporarily, press MUTE.

BLOCK CHANNEL function

With the CHANNEL BLOCK function, you can block specific channels. The TV will not be able to tune these channels with the CHANNEL s/t buttons or Channel Number buttons, unless you clear the setting.

This TV has 8 memory spaces total, 4 for TV mode and 4 for CABLE mode.

To block channels

1 Select a channel you want to block.

2 Select “BLOCK
CHANNEL” in the V-CHIP	ENABLE BLOCKING : [Y]N
	SET RATING

Set up

Preparation

Press the Number buttons (0-9) to enter the 4-digit code you have stored.

BLOCKING IS ACTIVE PLEASE ENTER PIN CODE TO TEMPORARILY UN-BLOCK

~~~–

CONTROL menu by	SET BLOCKING OPTIONS
pressing t or s.	NEW PIN CODE
	BLOCK CHANNEL
	MOVE[s t] SELECT[T S]

Operation

If the number is correct, the block mode will be released.

After 1 second, normal picture will appear.

SELECT[0-9] END[EXIT]

3 Press T or S to display the BLOCK CHANNEL menu.

BLOCK CHANNEL [SET]CLEAR

0 0 0 0

Basic

All blocking is disabled until the TV is turned off. It will be enabled when the power is reapplied.

If a wrong pin code is
entered, the message	INCORRECT PIN CODE
	PLEASE ENTER PIN CODE
appears.
	TO TEMPORARILY UN-BLOCK
Enter the correct code	~~~~
again.
	SELECT[0-9] END[EXIT]

4 Press T or S to select “SET”, then press t or s until the channel number to be blocked (“2” in this example) replaces “0” on the display.

SELECT[T S] SET[s t] END[EXIT]

BLOCK CHANNEL [SET]CLEAR

0 0 0 2

SELECT[T S] SET[s t] END[EXIT]

Selection Advanced Operation

5 Repeat steps 1 to 4 for other channels.

6 Select another channel before turning off the TV.

To restore channels

Reference

1 Select “CLEAR” following the above steps 2 to 4.

2 Press t or s until “0” replaces the channel numbers.

BLOCK CHANNEL SET [CLEAR]

15 10 6 2

SELECT[T S] CLEAR[s t] END[EXIT]

0 0 0 0

3 Press EXIT to erase the display.

2 7