Toshiba 22AV500U Using the PC settings feature, Setting the PC Audio, Setting the sleep timer

Chapter 6: Using the TV’s features

Using the PC settings feature

You can view an image from a PC on the TV screen.

When a PC is connected to the TV's PC IN terminal, you can use the PC Settings feature to make adjustments to the image. If the edges of the picture are cut off, readjust the Horizontal

Position and Vertical Position. If the picture is affected by interference, readjust the Clock Phase and Sampling Clock.

To adjust the PC settings:

1� Repeatedly press to select PC input mode

( “Selecting the video input source to view” page 34). � Press and open the Setup menu.

� Highlight PC Settings and press .

Setup

Installation

Sleep Timer

PC Settings

Note: If a PC is not connected or there is no pc input signal, this feature will be grayed out in the Setup menu.

� Press  or  to highlight the item you want to adjust. � Press  or  to make the appropriate adjustments.

Note: The screen is disrupted momentarily when adjusting the PC settings. This is not a sign of malfunction.

Mode	Description
Horizontal	Moves the picture left/right.
Position	The adjustment range is within ±50 from center.*
Vertical	Moves the picture up/down.
Position	The adjustment range is within ±10 from center.*
Clock Phase	Helps to reduce noise and sharpen the picture.
	The adjustment range is within ±16 from center.*
Sampling	Helps to reduce noise and minimize periodic
	vertical stripes on the screen.
Clock
	The adjustment range is within ±10 from center.*
Auto Adjust	Highlight this item then press	to get an
	optimum adjustment automatically.

*The default settings may vary depending on the input signal format.

Setting the PC Audio

This function allows you to output or mute the sound from your PC when connecting using the PC IN terminal and an analog RGB cable. ( page 19)

To set the PC Audio:

1�	Press	and open the Audio menu.
�	Highlight Audio Setup and press .

� Press  or  to select PC Audio and then press  or  to select No or Yes.

Yes: When viewing the PC input, the audio from the PC Audio input can be heard.

No: When viewing the PC input, there will be no audio.

Note: Because the PC and HDMI-1 inputs share the same set of analog audio inputs, the PC Audio menu setting influences the HDMI 1 Audio menu setting. If PC Audio is set to “No,” the HDMI 1 Audio setting changes to “Auto.” If PC Audio is set to “Yes,” the HDMI 1 Audio setting is set to “Digital” and is grayed out in the menu. (Also see item 3 on page 11 and “Setting the HDMI™ Audio mode” on page 32.)

Setting the sleep timer

You can set the sleep timer to turn off the TV after a set length of time (maximum of 180 minutes).

To set the sleep timer using the remote control:

Press on the remote control to set the length of time

until the TV turns off. Repeatedly press to increase the time in 10-minute increments, or press  or  to increase or decrease the time in 10-minute increments, to a maximum of 180 minutes.

To set the sleep timer using the on-screen menus:

1� Press and open the Setup menu. � Highlight Sleep Timer and press .

� Press the Number buttons to enter the length of time in 10-minute increments.

� Highlight Done and press .

Note: When a power failure occurs, the sleep timer setting may be cleared.

To display the remaining sleep time:

Press .

Note: A message will display on-screen when there is one minute remaining on the sleep timer.

To cancel the sleep timer:

Repeatedly press until it is set to 0 minute.

49