Toshiba SD-R5112 specifications 146+/-0.3 Less than plane

6.As for mounting bracket to incorporate this product into an equipment,

(1)When this product is incorporated into an equipment by using the mounting screw holes in the right and left side planes, the clearance between this product and the mounting bracket is too wide;

(2)When this product is incorporated into an equipment by using the mounting screw hole in the bottom, the surface of the mounting bracket is contorted.

If you use such mounting bracket as the above, this product will become deformed, which may cause operation failure. Therefore, it is necessary to take account of the mounting bracket which has the tolerances shown in Fig.1 or whose structure cannot cause this product to deform, as shown in Fig.2

146+/-0.3

less than plane 0.5

146.3 +- 0.20

Select screws, the length of which threaded

onto the product is within 3 +/- 0.5 mm

Fig.1

this product

before the fixing

When a large amount space is left, insert spacers, etc. to adjust the space less than 0.5 mm between the product and mounting bracket.

this product

after the fixing

mounting bracket

Fig.2

SD-R5112 Rev.1.0