GETTING STARTED
Read through this instruction manual. Unpack the unit.
Load batteries into the remote control.
Connect the unit, make sure the connections are correct.
Connect the power socket to wall outlet, power on the system via switch on rear of unit. Check the setting of the unit, TV and amplifier are correct and match each other.
1. PLAY A DISC
Switch on the power
Switch on the main power switch on the unit’s front panel, and switch on the TV set, and the amplifier if connected.
Set the system
Select the corresponding setting of the unit, TV set (AV or
Load a disc
Press the “OPEN” button | on the front panel or on the remote control, to open the disc tray. Load a disc | |
into the tray and press the “OPEN” button | again to close the disc tray. (Note: place the disc’s label side up, | |
blank side down.) |
|
|
Automatic Play
The unit will take several seconds to read the disc data, display the disc type logo at the left upper corner of the TV screen, and start playing automatically.
(MP3 disc would take longer time to upload the data on ‘Smart NAVI’ Menu when loading)
If a Disc Menu displayed on the screen:
1.Press the ► button to start playing, or
2. Press | button on the remote control to select the desired item and then press ENTER button to |
confirm.
A different kind of Disc Menu is displayed on the TV screen depending on the design and production of the disc.
12