UNDER CABINET INSTALLATION
Cabinet or
Shelf
OPEN |
Bottom
Edge
Molding
AUDIO
OX
| SENSOR AUTO PRO | AV/TV | PICTURE | VOLUME |
| CHANNEL | P0WER |
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an electrical outlet and a TV antenna or cable connection will facilitate a neat, easy installation. Do not mount the
2)If the location chosen has bottom edge molding it may be necessary to use the mounting spacers provided to effectively lower the
3)Measure the thickness of the bottom of the cabinet or shelf and the spacers chosen. Select the shortest screw length which will pass through the countersunk washer, kitchen cabinet and spacers with between 1/4” and 1 1/2” inches to spare
4)Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center punch the four holes indicated on the template and remove the template.
5)Carefully drill four 1/4” holes at the locations marked above. Place the screws chosen through the countersunk washers and then through the holes from the top down.
6)Screw the appropriate spacers on to the screws first, then position the
7)Plug the AC Power adapter into a nearby electrical outlet and into the receptacle marked DC 12v input at the rear of the
8)Connect your TV antenna or cable system to the antenna connector on the rear of the
9)Route the wires safely away from heat and moisture sources and secure them in place using the self adhesive wire mounting clip provided.