Description
| Connection |
Connecting to a Dolby Digital Amp | Connecting TV antenna / TV cable |
| Rear Panel |
Video Cable
75 ohm Coaxial Cable
or
Audio
Cable
To digital audio output
Receiver equipped with a
Dolby digital decoder
Front
SpeakerCenter Speaker
(left)
Sub
Speaker
Rear Speaker (left surround)
Front |
Speaker |
(right) |
Rear Speaker | 1. Prepare TV antenna or TV cable to see TV. |
(right surround) |
|
2. Connect TV antenna or TV cable to antenna jack on the back of your DVD Player.
●DVD disc must be recorded in Dolby Digtal.
●You must have Dolby Digital decoder and 6 channel Amp, 5 speakers and 1 bass woofer.
●You must set Digital Out of AC3 at "Raw" in Audio Setting
●This product is manufactured by technical
this symbol and trademark are reserved for Dolby Laboratories.
Dolby Laboratories Inc. All rights Reserved.
Caution �When connecting an amplifier equipped with Dolby Digital, connect it in the same way as shown above
�When connecting it, refer to the Audio system's manual.
�Be sure to adjust the receiver's volume to a moderate listening level. Otherwise, the speakers may be damaged by high volume levels.
�Turn off the receiver before you connect or disconnect the DVD player's power cord. If you leave the receiver power on, the speakers may be damaged.
Caution �When you connect TV antenna to DVD Player, be sure to turn off the power and unplug all of the equipment from the power souce before making any connections.
Warning �Choose Air channel or Cable channel by pressing menu key. �Air channel range : 2ch~69ch
�Cable channel range : 1ch~125ch
�There is Volume control when watching the tuner
18 | 19 |