INSTALLATION OVERVIEW
Installer’s Experience Level
The PRO900X is a sophisticated Entertainment MachineTM. In addition to making the necessary
connections, installation will most likely require a series of adjustments to ensure the projected image is not distorted. If these adjustments are not accu-
rate, the operation of the PRO900X could be adversely affected. For this reason, installation and setup should be performed by a qualified service person and should con- form to all local codes. The installer must also adhere to the pertinent Articles of the National Electrical Code (NEC), pertinent Regulations of the Federal Communications Commission (FCC), and all relevant codes of local regulat- ing agencies.
Installation Considerations Before you install the PRO900X...
Ventilation
perforations on the sides of the cabinet. Do not block these vents or you will shorten the life of the PRO900X.
Power Cord
pin. This plug will only fit into a
This is a safety feature. If you are unable to insert the plug into the outlet, contact an electrician to replace the obsolete outlet. Do not defeat the safety purpose of the
Power Source
60 Hertz AC or 230 volt 50/60 Hertz AC. Do not attempt to operate it on DC current.
The PRO900X is configured at the factory for 120 volt, 60 Hz operation. A service adjustment is necessary to permit the unit to operate on 230 volt, 50/60 Hz. See Changing From 120 VAC To 230 VAC in the Setup and Alignment sec- tion for details.
National Power Cord Requirements U.S. / Canada
•The power cord must be UL listed and CSA certified.
•The minimum specifications for the power cord are as follows: No. 18 AWG, Type SV or SJ, 3 conductor.
•The power cord must have a rated cur-
rent capacity of at least 10 amperes.
• The attachment plug must be an
Other Countries
• The cord set fittings must bear the
certification mark of the agency responsible for evaluation in a specific country. Acceptable agencies include the fol-
lowing: |
|
BSI (United Kingdom) | Nemko (Norway) |
CEBEC (Belgium) | OVE (Austria) |
DEMKO (Denmark) | SEMKO (Sweden) |
EANSW (Australia) | SEV (Switzerland) |
SETI (Finland) | UTE (France) |
IMQ (Italy) | VDE (Germany) |
KEMA (The Netherlands) | MITI (Japan) |
•The flexible cord must be of a HAR (harmonized) type
•The cord set must have a current capacity of at least 10 amperes and a nominal voltage rating of 125 or 250 VAC, as required by the specific country’s power system.
P A G E 4 | Entertainment MachineTM is a registered trademark of Zenith Electronics Corporation | |
|
|
|