NAD T 513 owner manual Troubleshooting, Symptom Cause Correction

Reference

TROUBLESHOOTING

Check the following guide for the possible cause of a problem before contacting service.

SYMPTOM	CAUSE		CORRECTION
No power.	• The power cord is disconnected.	• Plug the power cord into the wall outlet securely.
The power is on, but the DVD player does not	• No disc is inserted.	• Insert a disc. (Check that the DVD or, audio CD
			indicator in the display window is lit.)
work.
No picture.	• The TV is not set to receive DVD signal output.	• Select the appropriate video input mode on the
			TV so the picture from the DVD player appears
			on the TV screen.
	• The video cable is not connected securely.	• Connect the video cable securely.
	• The connected TV power is turned off.	• Turn on the TV.
No sound.	• The equipment connected with the audio cable	• Select the correct input mode of the audio
	is not set to receive DVD signal output.		receiver so you can listen to the sound from the
			DVD player.
	• The audio cables are not connected securely.	• Connect the audio cable securely.
	• The power of the equipment connected with the	• Turn on the equipment connected with the
	audio cable is turned off.		audio cable.
	• The Digital Audio Output is set to the wrong	• Set the Digital Audio Output to the correct
	position.		position, then turn on the DVD player again by
			pressing ON.
The playback picture is poor.	• The disc is dirty.	•	Clean the disc.
The DVD player does not start playback.	• No disc is inserted.	• Insert a disc. (Check that the DVD or audio CD
			indicator in the DVD display is lit.)
	• An unplayable disc is inserted.	• Insert a playable disc. (Check the disc type, color
			system, and Regional code.)
	• The disc is placed upside down.	• Place the disc with the playback side down.
	• The disc is not placed within the guide.	• Place the disc on the disc tray correctly inside the
			guide.
	• The disc is dirty.	•	Clean the disc.
	• The Rating level is set.	• Cancel the Rating function or change the rating
			level.
The remote control does not work properly.	• The remote control is not pointed at the remote	• Point the remote control at the remote sensor of
	sensor of the DVD player.		the DVD player.
	• The remote control is too far from the DVD	• Operate the remote control within 23 ft (7 m).
	player.
	• There is an obstacle in the path of the remote	•	Remove the obstacle.
	control and the DVD player.
	• The batteries in the remote control are	• Replace the batteries with new ones.
	exhausted.

SVENSKA PORTUGUÊS ITALIANO ESPAÑOL NEDERLANDS DEUTSCH FRANÇAIS ENGLISH

25