Activating and setting the clock

Press any button (other than Volume Up/Down) to activate the display. In the Main menu, each category of Silver Series component is represented by its own icon. Refer to figure No.2.

To set up the S70 for your system:

•From the Main Menu on the remote control, press the button next to where it indicates "SYSTEM" in the display.

•The display will change to System Set-up Menu. Refer also to figure No.3

•The display will show several components, such as "AMP", "PREAMP", "TUNER", "CD" with corresponding icons. By pressing the button next to the component you can select or de-select a component for the Main Menu. A tick-mark next to the component will indicate whether component has been selected. For instance, if your system comprises the NAD S200 amplifier, S400 tuner and S500 CD player make sure the boxes for amp, tuner and CD player are ticked, the others not.

•Press the button next to "EXIT" at the bottom to leave and save the set-up and return to Main Menu.

Set-up of the S70 remote control: S100 or S170 Preamp selection

Note that within "PREAMP" Component one can choose from 2 different models: the S100 Stereo pre-amp and the S170 AV Pre-amp/Processor:

•To select, press and hold down the button next to "PREAMP" for 2 seconds. The display will change to show the sub-menu with "S100" and "S170". A tick-mark indicates which of the two is selected.

•Press the button next to the model that is part of your system (refer to model number as mentioned on the preamp's front panel), a tick-mark indicates which model has been selected.

•Press the button next to "EXIT" at the bottom to return to the System Set-up Menu.

•In System Set-up Menu, make sure that "PREAMP" has a tick-mark next to it, to indicate it has been selected.

NOTE: If your NAD Silver Series component is not available from the System Set- up menu, your S70 can be updated in many cases. Consult your NAD dealer.

Activating and setting the clock

The S70 Remote Control also has a clock built-in, which gives you extra facilities such as Sleep Timer and Timer function. For these to function, you need to activate and set the clock:

•From the Main Menu, press the button next to "SYSTEM".

•In the System Set-up Menu, activate the clock by pressing the button next to "CLOCK"; a tick mark will appear to indicate that the clock has been activated.

•Press the button next to "CLOCK" for 2 seconds

•The Clock Set-up Menu allows for adjusting the clock. Use the 24-hour format to enter the correct time (for example, 2:15PM would be 14:15) by pressing the buttons next to "HR+" (to adjust hours upwards), "HR-" (adjust hours downwards), "MIN +" (adjust minutes upwards), "MIN -" (adjust minutes downwards). Refer also to figure No.4.

•Press the button next to "EXIT" to return to System Set-up Menu.

•Press the button next to "EXIT" to return to Main Menu.

NOTE: If you choose to de-select (no tick-mark) from the System Set-up Menu you will have to adjust the clock again next time you activate it.

Adjusting display contrast

The NAD S70’s display contrast can be adjusted to optimise legibility from a wide viewing angle. The factory setting will be suitable in almost all cases but under exceptional circumstances or if the battery is becoming very weak it may be