Connecting the Power/Turning on the DPS-5.4

Integra instruction manual Connecting the Power/Turning on the DPS-5.4

Connecting the Power/Turning on the DPS-5.4

Before connecting

•The DPS-5.4 is shipped with the Power switch in the on position ( On). When the power cord is plugged in for the ﬁrst time, the DPS-5.4 will automatically enter the standby state and the Standby indicator will light (same condition after step 2 below).

•Make sure that all the connections on pages 17 – 21 are complete (the connection to a TV is required).

Standby/On

Standby/On		Open/Close		Stop	Play
		Open/Close	Pause	Stop	Play
	Display	Play Mode
Standby
Power	Dimmer	Clear

On Off

DPS-5.4

Power

	1	Plug the supplied power cord
	1	into the AC INLET and then into
		into the AC INLET and then into
		the power outlet on the wall.
		• Do not use a power cord other than
		the one supplied with the DPS-5.4.
		The power cord supplied is designed
		for use with the DPS-5.4 and should

Standby/On

Press Standby/On on the DVD Player or On on the remote con- troller.

The DVD Player turns on and the Standby indicator turns off.

•To put the DVD Player in the standby mode, press Standby/On on the DVD Player, or Standby on the remote controller. Be sure to set the volume to minimum before putting the DVD Player in the standby mode for the next use to avoid sudden loud sound reproduction.

•While the Standby indicator lights up, the DVD Player can receive sig- nals from the remote controller. However, if you press Power on the DVD Player to switch off the main power, the remote controller cannot be used to turn on the DVD Player.

•Setting the Standby button to standby does not shut off the power com- pletely.

not be used with any other device.

• Never have the power cord discon-

nected from the DPS-5.4 while the

other end is plugged into the wall outlet. Doing so may cause an elec- tric shock. Always connect by plug- ging into the wall outlet last and disconnect by unplugging from the wall outlet ﬁrst.

To a wall outlet

2			Press Power to switch on the
			Press Power to switch on the
			main power.
	Power		The DVD Player enters standby mode.
			The Standby indicator lights up.
	On	Off	The Standby indicator lights up.
			• The buttons on the remote controller
			do not operate if the Power switch is
			set to Off.

•To switch off the main power, press Power again.

Note:

•This player features a screen saver and an auto power off function. If the player is stopped and no button is pressed for ﬁve minutes, the screen saver starts. If the disc tray is closed but no disc is playing and no control is pressed for 30 minutes, the player automatically goes into standby.