Plug & Play Feature

ENG

When the television is initially powered ON, three basic customer settings proceed automatically and subsequently: setting the language, channel and clock.

Plug & Play

Ant. Input Check

Auto Store

Exit

P 1
471	MHz	48 %

Exit


	Time
	Clock	- - : - - AM


	Move	Exit

ENJOY YOUR WATCHING

				Function
		Language : English
		Language : English
		Time
		Plug & Play
		Blue Screen		: Off
		Child Lock
		Demonstration

1If the television is in Standby mode, press the POWER button on the remote control.

Result: The message “Plug & Play” is displayed. It flickers for a little while and then the “Language” menu is automatically displayed.

2Press the ▲ or ▼ button to select required language. Press the MENU button to enter the language, and then the message “Ant. Input Check” is displayed.

➣If any language is not selected on the “Language” menu, the “Language” menu will be displayed about 30 seconds later.

3Make sure that the antenna is connected to the TV. And then press the + or – button to store the channels (refer to “Storing the Channels Automatically” on page 14).

Result: The horizontal bar is displayed, and then channels are stored in an order which reflects their positions in the frequency range.

4When searching and storing is complete, the “Time” menu is displayed.

5Press the + or – button to move to the hour or minute. Set the hour or minute by pressing the ▲ or ▼ button (refer to “Setting and Displaying the Current Time” on page 28).

6When you have finished, press the MENU button.

Result: The message “ENJOY YOUR WATCHING” is displayed, and then the channel which has been stored will be activated.

7If you want to reset this feature...

1 Press the MENU button.

2 Press the ▲ or ▼ button to select the “Function”, and then press the + or – button.

3 Select the “Plug & Play” by pressing the ▲ or ▼ button, and then press the + or – button.

Result: The message “Plug & Play” is displayed.

Select

Enter

Exit