Samsung 17A11 Storing the Channels Automatically, Selecting a Channel Numbered Ten or Over, Then

KS1_01818B_02_ENG_UMG 11/18/03 10:09 AM Page 12

Storing the Channels Automatically

ENG

		Picture
	Mode	Custom
	Adjust
	Size	: Normal
Select	Enter	Exit
		Channel

Auto Store

Manual Store

Add/Erase

Fine Tune

Sort

Select		Enter		Exit
P 1
471 MHz				48 %
	Exit
	Sort			Channel
	From		: P 1
	To		: P--
	Store	:		?
Select		Adjust		Exit

You can scan the frequency ranges available on your television and in your country and store all the channels found automatically.

The channels are stored in the order in which they appear in the frequency bands. It is possible that the automatically allocated numbers may not correspond to those by which you wish to identify the channels. If this is the case, refer to “Sorting the Stored Channels” on page 16.

1Press the MENU button.

2Press the ▲ or ▼ button to select the “Channel”.

3Press the + or – button to select the “Auto Store”.

4Press the + or – button again.

Result: The horizontal bar is displayed, and then channels are stored in an order which reflects their positions in the frequency range. Finally, the search will end automatically.

5When searching and storing is complete, the “Sort” menu is displayed.

To...	Then...
Sort the stored channels	Go to Step 4 of the “Sorting
into the desired numerical order	the Stored Channels”
	procedure on page 16.
Exit the channel store function	Press the MENU button
without sorting the channels	repeatedly until the menus
	disappear.

➣If sound does not work regularly after storing channels, select the sound system which best corresponds in “Manual Store” menu (refer to the opposite page).

Selecting a Channel Numbered Ten or Over

When using the numeric buttons to select a channel stored at programme position ten or higher, follow the instructions below.

1 Press the -/--button.

Result: The “--” symbol is displayed.

2 Enter the two-digit channel number.

Example: To select channel 42, press 4, followed by 2.

12