Channel - Memorizing the Channels
Channel - Fine Tune
Setup - Time
Your TV can memorize and store all of the available channels for both
This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels: “Air/Cable”, “Auto Program” and “Add/Delete”.
The Fine Tuning function lets you manually adjust the TV’s tuner if you have difficulty tuning channels.
Adjust the fine tuning by pressing the ◄ or ► button.
To store the fine tuning setting in the TV’s memory, press the
| Fine Tune | |||
P 3 | 0 |
| ||
| Reset | |||
Move |
|
| Save | |
Adjust |
|
| Return |
Clock
Setting the clock is necessary in order to use the various timer features of the TV. Also, you can check the time while watching the TV. (Just press the INFO button.)
|
|
|
| Time |
|
| Clock |
| |||
| On Timer | ||||
| Off Timer | ||||
|
| Enter |
| Return | |
| Move |
| |||
|
|
Air/Cable |
|
|
|
| Channel |
MENU button.
On Timer / Off Timer |
Before your TV can begin |
| Air/Cable | :Air | ► |
|
memorizing the available |
| Auto Program | ► | ||
| Add/Delete |
| ► | ||
channels, you must specify |
| Fine Tune |
| ► | |
the type of signal source |
|
|
|
|
|
that is connected to the TV |
|
|
|
|
|
|
|
|
|
| |
(i.e., an antenna or a cable | Move | Enter | Return | ||
system). |
|
|
|
|
|
Select “Air” or “Cable” by pressing the ENTER button.
To reset the fine tuning to “0”, select ”Reset” by pressing the ▲ or ▼ button, then press the ENTER button.
You can set the On/Off timers so that the TV will switch on |
or off automatically at the time you select. |
➢ You must set the clock first. |
☛ Auto Power Off |
When you set the timer “On”, the TV will eventually turn |
off, if no controls are operated for 3 hours after the TV was |
turned on by timer. This function is only available in timer |
“On” mode and prevents overheating or leakages, which |
Auto Program
All available channels are automatically stored in memory when channels are selected by the direct tuning function.
Press the ENTER button at any time to interrupt the memorization process.
Search
Air 3
3%
Stop
Enter Return
may occur if a TV is on for too long. |
Add/Delete
You can add or delete a channel to display the channels you want only. To use the “Add/Delete” function, first run Auto Program.
Select “Deleted” or “Added” by pressing the ENTER button.
Add/Delete
▲ More
2 : Deleted
3: Deleted
4 : Deleted
| 5 | : Deleted |
|
| 6 | : Deleted |
|
| ▼ More |
|
|
Move | Enter | Return |
Sleep Timer
You can select a time period of between 30 and 180 minutes after which the TV automatically switches to standby mode.
Press the SLEEP button on the
remote control repeatedly until the 30 Min. appropriate time interval appears
(any of the preset values from “30 Min.” to “180 Min.”).
English - 4