Wall Installation Instructions
Installation Notes
1 Do not install the PDP on any place other than vertical walls.
2 To protect the performance of the PDP and prevent troubles, avoid the following.
•Do not install next to smoke and fire detectors.
•Do not install in an area subjected to vibration.
•Do not install in an area subjected to high voltage.
•Do not install near or around any heating apparatus.
3 Use only recommended parts and components.
4 Do not install in the wall.
Parts (Wall attachment panel is sold separately. Check with your dealer)
Wall attachment panel
Installing the Display on the Wall Attachment Panel
See the drawing of the wall attachment panel shown in page 14 to check for
1 the stability of the wall where the PDP is to be installed. If the wall is not enough strong to support the PDP, strengthen the wall before installation.
Fix the wall attachment panel on the wall using bolts as shown in the following
2 figure: Fixing bolts must protrude from the wall appox. 0.6 inches.
Using the wall attachment panel, you may adjust the angle of the display from
3 0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance each using the angle control holes on the sides of the panel.
bolt | Insulation holder |
When the angle has been set to 5 degrees.
Angle
control
holes
When the angle has been set to 15 degrees.
When the panel hasn't been tilted.
5degrees of tilt 
10degrees of tilt 
15degrees of tilt 
No tilt 
20 degrees of tilt 
14
Continued...
15