■Contents (when Source is set to USB or TV Memory)
You can select a folder on the USB Device/TV memory with music or photo files to be played when the TV turns on automatically.
N If the folder name is too long, the folder can not be selected.
N If you are using two of the same type USB device, be sure the folder names are different so the correct USB is read.
■Repeat
Select Once, Everyday, Mon~Fri, Mon~Sat, Sat~Sun or Manual.
N When Manual is selected, press the ► button to select the desired day of the week. Press the ENTEREbutton over the desired day and the cmark will appear.
N You can set the hour, minute and channel by pressing the number buttons on the remote control.
N Auto Power Off
When you set the timer On, the television will eventually turn off, if no controls are operated for 3 hours after the TV was turned on by the timer. This function is only available in timer On mode and prevents overheating, which may occur if a TV is on for too long time.
¦Network Connection
You can set up the Internet Protocol so that you can communicate with various connected networks.
❑Network Connection - Cable
■LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below. Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do not have to enter them manually.
1. | Connect the LAN port on the rear panel of the TV and the external modem with a LAN Cable. | ||
2. | Connect the Modem on the wall and the external modem with a Modem Cable. | ||
| The Modem Port on the Wall | External Modem | TV Rear Panel |
| (ADSL / VDSL / Cable TV) |
| |
|
|
| |
|
| 2 Modem Cable | 1 LAN Cable |
You can connect the LAN via a Sharer (Router).
The Modem Port on the Wall | External Modem | TV Rear Panel |
| (ADSL / VDSL / Cable TV) | IP Sharer |
Modem Cable | LAN Cable | LAN Cable |