
S56A_UI_ENG_EU 8/30/03 10:47 AM Page 12
Plug & Play Feature (depending on the model)
ENG
Plug & Play
Language
EnglishPortuguês
DeuschItaliano
Français Sverige
Nederland Türkçe
Español EÏÏËÓÈο
Adjust | Select |
Ant. Input : Check
Exit
P 1 - - - - - |
|
471 MHz | 48 % |
Exit
Time
Clock 11 : 35
Move | Exit |
ENJOY YOUR WATCHING
|
|
|
|
|
|
|
| Function |
|
| Language : English |
| ||
| Time |
| √ |
|
| Plug & Play | √ |
| |
| Blue Screen | : Off |
| |
| Child Lock | √ |
| |
| Demonstration | √ |
| |
|
|
|
|
|
|
|
|
| |
| Select | Enter | Exit |
|
|
|
|
|
|
When the television is initially powered ON, three basic customer settings proceed automatically and subsequently: setting the language, channel and clock.
1If the television is in Standby mode, press the POWER () button on the remote control.
Result: The message Plug & Play is displayed. It flickers for a little while and then the “Language” menu is automatically displayed.
2Press the ▲ or ▼ button to select required language. Press the MENU () button to enter the language, and then the message
Ant. Input : Check is displayed.
➣If any language is not selected on the Language menu, the “Language” menu will be displayed about 30 seconds later.
3Make sure that the antenna is connected to the TV. And then press the œ or √ button to store the channels (refer to “Storing the Channels Automatically” on page 14).
Result: The horizontal bar is displayed, and then channels are stored in an order which reflects their positions in the frequency range.
4When searching and storing is complete, the Time menu is displayed.
5Press the œ or √ button to move to the hour or minute. Set the hour or minute by pressing the ▲ or ▼ button (refer to “Setting and Displaying the Current Time” on page 31).
6When you have finished, press the MENU () button.
Result: The message ENJOY YOUR WATCHING is displayed, and then the channel which has been stored will be activated.
7If you want to reset this feature...
1 Press the MENU () button.
2 Press the ▲ or ▼ button to select the Function, and then press the œ or √ button.
3 Select the Plug & Play by pressing the ▲ or ▼ button, and then press the œ or √ button.
Result: The message Plug & Play is displayed.
12