| Introduction |
A - | Captive Screw |
B - | Wall Bracket |
C - | Hinge (Left) |
D - | Hinge (Right) |
2.Before drilling into the wall, check if the length between the two locking holes at the back of the product is correct.
If the length is too short or long, loosen all or some of the 4screws on the wall bracket to adjust the length.
A - | Length between the two locking holes |
3.Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole. Match each of the brackets and hinge holes to the corresponding anchor holes and insert and tighten the 11 screws A.
To mount the product on the wall bracket
The shape of the product may vary depending on the model. (The assemblies of the plastic hanger and the screw are the same)