Connecting and Preparing Your TV
Checking Parts
Owner’s Instructions | Remote Control/ | Power Cord | Warranty Card/ | |
| AAA Batteries (2ea) |
|
| |
|
|
|
| Safety Guide Manual |
|
|
|
| (Not available in all locations) |
Screws (4ea) | Ferrite Core for Power | ||
|
| (Refer to page 30) | Cord (1ea) |
N The ferrite core is used to shield the cable from interference. When connecting a cable, open the ferrite core and clip it around the cable near the plug.
Using the Stand-Base
N Two or more people should carry the PDP. Never lay the PDP on the floor because of possible damage to the screen. Always keep the PDP upright.
N The PDP can rotate 20 degrees in right and left directions.
How to assemble the Stand-Base (depending on the model)
Using the 4 screws for securing the stand base and the monitor, firmly attach the monitor to the stand base.
(The exterior of the set may be different than the picture.)
Warning
Firmly secure the stand to the TV before moving it, as the stand may fall and could cause serious injury.
N Two or more people should carry the TV. Never lay the TV on the floor because of possible damage to the screen.
Always store the TV upright.
In case of installing your TV on the wall, close the cover (1) on the
English -