Samsung PS42D4ST manual Inserting the Batteries in the Remote Control

Page 11

Inserting the Batteries in the Remote Control

ENG

You must insert or replace the batteries in the remote control when you:

◆Purchase the PDP

◆ Find that the remote control is no longer operating correctly

1Remove the cover on the rear of the remote control by pressing the symbol downwards and then pulling firmly to remove it.

2Insert two R03, UM4, “AAA” 1.5V or equivalent batteries taking

care to respect the polarities:

◆ - on the battery against - on the remote control

◆+ on the battery against + on the remote control

3 Replace the cover by aligning it with the base of the remote control and pressing it back into place.

Assembling the Stand-Base

Fit the Stand-Base into the guide hole on the bottom of the monitor and tighten the left and right sides using four screws for each side.

➢◆ Two or more people should carry the PDP. Never lay the PDP on the floor because of possible damage to the screen. Always store the PDP upright.

11

Image 11

Contents PDP-MONITOR ENG Important Warranty Information Regarding PDP Format Viewing Cell Defect WarrantyUser Instructions Screen Image retentionChecking Parts Separated Sales Contents Contents SymbolsFront Panel Your New Plasma Display PanelRear Panel Picture Still Becoming Familiar with the Remote ControlInserting the Batteries in the Remote Control Installation Notes Installing the Display on the Wall Attachment PanelExterior of the PDP may be different than the picture Connecting Speakers Ferrite Cores Mains lead is attached to the rear of your PDP Switching On and OffChanging the Picture Mode Selecting the Color System Video or S-Video ModeNormal Warm1 Warm2 Cool2 Cool1 Adjusting the Picture SettingsCustom PC mode only Color1 Color2 Color3 Adjusting the Picture Settings PC or DVI ModeViewing requirements Selecting the Picture SizeFreezing the Current Picture Changing the Sound ModeAdjusting the Sound Settings Pseudo Stereo / Virtual Surround Extra Sound SettingsAuto Volume MelodyAdjusting the Image Preferences PC Mode Locking the Control buttons Setting the MDC Multiple Display ControlYou can prevent the residual image of the PDP Protecting the Screen BurningDisplaying the PC Information Displaying the Setting InformationSetting and Displaying the Current Time Absent Power Off Switching On and Off AutomaticallySetting the Film Mode Video S-Video Component PC DVI Viewing the Picture In Picture PIPSEL Easy functions of remote controlListening to the Sound of the Sub Picture Viewing Pictures From External SourcesRear of the PDP Connecting to the Audio/Video InputConnecting to the DVD/DTV Receiver Input Connecting to the S-Video InputConnecting to the Rgbpc Input Connecting to the DVI InputSetting up Your PC Software Windows only DVI Input Connector 24Pin Pin ConfigurationsRgbpc Input Connector 15Pin RS232C Connector 9PinInput Mode PC/DVI Power Saver PC mode only Liquids Care and MaintenanceIdentifying Problems TemperatureMemo Memo After Sales Service