GE 05GP005 instruction

Mounting Your Spacemaker™

B.	Select spacers which are approximately 1⁄4” shorter than
	the overhang. Two or three spacers can be used together
	to make length of 1⁄4” to 1-3⁄4” at 1⁄4” increments.
C.	While holding the Bracket and selected spacers in place
	under the cabinet, check to see that the Bracket clears the
	overhang so the TV can be easily slid onto the Bracket or
	removed for portable use.
7. Select proper length of screws.

8.Position Mounting Bracket under cabinet as shown below and match the screw holes.

Screw

Washer

A. Only four screws are needed. The size you need depends

upon your type of cabinet.

B. Holding the selected spacers for one of the screw holes

under the cabinet, install a washer and screw inside the

Spacer

Hex Nut

Cabinet Bottom

cabinet using one of the three lengths of screws provid-

ed.

C. Use the Screw Guide you cut from the Mounting Guide

to determine if the screw is the proper length for your

cabinet. (See the diagram below).

Mounting Bracket

9.Attach Mounting Bracket to cabinet.

A.First mount one corner of the Bracket. Hold the Bracket and spacer(s) in place and insert the screw from the inside of the cabinet down through washer and drilled hole or down through countersink and drilled hole.

5/8”

1/4” to 5/8” for proper mounting

Spacer(s)

1/4”

Screw

Guide

Note: The washers must be used on metal cabinets and on wood cabinets if you did not countersink the drilled holes.

B.	Position the washer flat-side down and place screw into
	screw hole, through the spacer(s), and through the screw
	hole in the Mounting Bracket.
C.	Place a nut into the cylinder at the bottom of the
	Mounting Bracket screw hole. Hold nut in place (if neces-
	sary, use the top of a pencil). While maintaining upward
	pressure on the Mounting Bracket, finger tighten the

D.If the screw threads fall within the shaded area of the Screw Guide, then the selected screw is of the proper length for mounting the Bracket.

E.If the threads end above or below the shaded area, try one of the other screws provided. (Screw length must fall into the shaded area on the Screw Guide for proper mounting).

CAUTION: If the screw is too short, it will not screw into the nut far enough to securely hold the TV. If the screw is too long, it may protrude below the Bracket, and the TV will hit it when sliding onto the Bracket.

Note: If none of the screws provided are the proper length for your cabinet, you can do one of the following:

a)Increase the spacer length by 1⁄4” and try one of the longer screws provided.

b)Purchase proper length screws at your local hardware store (type #10-32).

screw. Do not tighten firmly until all four screws have

been started.

D. Align each of the remaining three Mounting Bracket

screw holes with the drilled holes and properly position

the selected spacers. Install washers, screws, and nuts as

previously described. Now, finish tightening the four

screws but do not over-tighten them.

Mounting Your Spacemaker™

Select spacers which are approximately 1⁄4” shorter than