Connecting the Antenna to Your TV

Getting Started

CAUTION!

Be very careful when you’re connecting the antenna to the power injector and to your TV—you might damage your TV if you install the power injector backwards! Make sure you pay close attention to the jack you use when connecting to the power injector.

To connect the antenna to your TV, follow these steps:

Out to

TINU ANNTENA OT

Out to

ANT

1.Connect the coax downlead from the antenna to the TO ANTENNA UNIT jack on the power injector.

From

Antenna

2. Connect the short coaxial cable built into the power injector to your TV’s ANTENNA IN jack.

Note: If your TV has screw terminals for the VHF/UHF connection, connect a 75-ohm to a 300-ohm transformer (not supplied) between the power injector and the VHF/UHF terminals.

	TV	Power Injector
	Coax	Power Injector
	Coax

	TV	From
	TV	Antenna
	Coax	Antenna
	Coax
		Splitter
	Alternative	Power Injector
	Alternative
	Component or
	Display

If you want to split the signal coming from the antenna, connect the short coaxial cable built into the power injector to your splitter. DO NOT PUT

THE SIGNAL SPLITTER BETWEEN THE INJECTOR AND THE ANTENNA.

3.Plug the injector’s built-in power supply to the outlet after all connections are complete.

IMPORTANT: This power unit is intended to be oriented in a vertical or floor mount position.

ANT806	_IB_01.indd 6

		5/2/07 3:29:28 PM