1 in.
SOLDER TO
ANTENNA WIRE
1 in.
WIRE TIES
wire. You should make sure that the center conductor fits through the hole in the center pin, and there are no stray strands being folded backwards. This will have the unfortunate tendency of shorting out your antenna. The connector should cover the braided wire and trap it against the reducer. Snug it down so that it is firmly on the wire. The braided shield should be caught between the reducer and connector and be held in very tightly.
Before you solder, it is a good idea to use an ohmmeter to check to see if your center pin may be shorted to the outer braid. To do this, simply place the ohmmeter across the two pins. Infinite ohms and you’re in the clear!
Using your soldering gun, solder the center conductor onto the pin, and trim off any extra. Be sure that the solder flows easily into the hole, and does not bead on the outside. This indicates a cold solder joint (more heat needed), and also will not allow the connector to plug into your radio easily. Next, solder into each of the holes on the side of the connector. You should be able to see the braided wire through at least some of the holes. Once more, check with your ohmmeter to see if there is a short. Please note that it is not recommended that you leave the connector unsoldered. Moisture will quickly cause all of your connections inside to go bad.
Screw the large outer ring onto the
Begin by stripping the outer insulation off of the coaxial cable like you have done before. Bend the braid back, and twist it together to form a thick
RAMSEY DA SERIES DIPOLE ANTENNA | Page 13 |