Radio Shack 20-422 Scanning Channels, Moving a Frequency from a Monitor Memory to a Channel

You can also select a monitor memory by repeatedly pressing MONITOR until the desired monitor memory appears.

Note: To listen to the monitor memories, the priority channel feature must be turned off (see “Priority” on Page 20).

MOVING A FREQUENCY FROM A MONITOR MEMORY TO A CHANNEL

1.If the scanner is scanning, press

MANUAL.

2.Use the number keys to enter the channel number where you want to store the monitor frequency, then press PROGRAM. PGM appears.

3.Press MONITOR. The channel num- ber flashes and the frequency stored in the monitor memory and the monitor memory’s number appear.

4.Use the number keys to enter the monitor memory number that has the frequency you want to store into the channel. The frequency ap- pears.

5.Press E. The scanner stores the fre- quency in the selected channel.

DELETING A FREQUENCY FROM A CHANNEL

1.If the scanner is scanning, press

MANUAL.

2.Use the number keys to enter the channel number containing the fre- quency you want to delete.

3.Press PROGRAM.

4.Press 0 then E. The frequency is deleted.

To replace a frequency stored in a moni- tor memory, store a new frequency in that monitor memory.

SCANNING CHANNELS

Note: You cannot scan channels until you have stored frequencies in them.

To scan channels stored in the channel- storage banks, press SCAN. The scan- ner scans through all channels in the ac- tive banks.

To select one or more channel-storage banks while scanning, select each bank you want to scan by pressing its number key so the bank’s number appears on the display.

Note: The channels for each bank are listed above the scanner’s number keys.

To turn off channel-storage banks, press the number key for each of the bank(s) so the bank’s number disappears. The scanner does not scan any of the stored channels within banks you have turned off.

17