OPERATION
1.Select the desired source by moving the switch located on the front of the wall plate. Select either “AIR” or “CABLE”. AIR will activate the roof mounted antenna which will provide
2.Next turn on all TV’s and access your on screen menu. (refer to your TV owner’s manual). If you selected “AIR” ensure that TV tuner is set to receive
3.If you selected “CABLE”, then set your TV tuner to cable and activate the TV’s auto programming sequence to scan / store available channels.
4.The 7.5 Amp DC Receptacle is designed to power DC TV’s or other small amperage DC devices. The 7.5A fuse located on the front of the wall plate protects this receptacle and the power to the roof antenna. If this fuse blows then the antenna will not work. Do not connect high current devices.
5.Other wall plates do not have the DC receptacle and are fused at 1 Amp to protect the electronics.
*Warning: Replace Fuse with the same Fuse type & current rating. Failure to do so may cause damage and void warranty.
SPECIFICATIONS
POWER SUPPLY……………………………………………….9 – 16 VDC negative ground at 85mA
IMPEDANCE…………………………………………………………………………………….....75Ω
FREQUENCY RANGE………………………..40 – 850MHz, 500 – 1700KHz (AM, FM, VHF, UHF)
GAIN…………………………………………………………………………………..….15dB (typical)
GAIN FLATNESS………………………………………………………………….……0.5dB (typical)
OIP3………………………………………………………………………………..…80dBmV (typical)
OPERATING
OVERALL DIMENSIONS……………………………………………….8”(H) x 12.75”(W) x 14”(D)
Specifications subject to change without notice.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following 2 conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate this equipment.
7.5AMP MAX DC RECEPTACLE
7.5AMP MINI ATM FUSE
1 AMP MINI ATM FUSE
5
ANWP12V
LED INDICATOR
SWITCH
TV1 OUTPUT
CONNECT TO TV
FIGURE 8
ANWP
LED INDICATOR
SWITCH
TV1 OUTPUT
CONNECT TO TV
FIGURE 9