42PD8800TA 55PD8800TA
PREPARATION
Remote Control Batteries Installation
This remote control operates on 2 “AA” batteries.
1. Open the battery compartment cover
Slide open the battery compartment cover on the backside of the remote control in the direction of an arrow.
2. Install the batteries
Install 2 “AA” batteries (included) making sure the polarities match the indication inside the compartment.
3. Close the battery compartment cover.
To close the battery compartment cover, slide the cover in the direction of an arrow till it clicks shut.
CAUTION
It could cause corrosion or battery leakage and may result in physical injury and/or property damage including fire.
Never mix used and new batteries in the device.
Replace all the batteries in a device at the same time.
Remove the batteries if the remote control is not going to be used for an extended period of time.
To avoid possible failure, read the following instructions and handle the remote control properly.
Do not drop or have an impact on the remote control.
Do not spill water or any liquid on the remote control.
Do not place the remote control on the wet object.
Do not place the remote control under the direct sunlight or near sources of excessive heat.
Caution When Moving the Main Unit
As this product is heavy, whenever it is moved, two people are required to transport it safely.
42PD8800TA |
|
Whenever the unit is moved, | Handgrips |
it should be lifted forwards |
|
using the two handgrips at |
|
the back, and the unit should |
|
then be held at the base on |
|
both sides for stability. |
|
55PD8800TA
When carrying this product, hold it by the top and bottom on both ends.
11
HITACHI
Downloaded From | 2005/11/09 9:45:51 |