Audio-Technica ATW-R1810 manual Specifications, Top Bottom

	87
	ATW-R1810
Specifications
Receiving system	Dual independent RF sections, automatic-
Image rejection	switching diversity
	>50 dB typical
Signal-to-noise ratio	104 dB at 30 kHz deviation (A-weighted),
	maximum modulation 37 kHz
Total harmonic distortion	≤1% (±10 kHz deviation at 1 kHz)
Sensitivity	25 dBµV, (S/N 60 dB at 5 kHz deviation,
	A-weighted)
Audio output (balanced)	27 mV (at 1 kHz, ±5 kHz deviation)
Output connector	3-pin mini XLR (TA3M-type)
Monitor headphone output (typical)	35 mW max., 32 ohm load
Monitor headphone jack	3.5 mm TRS, signals on both Tip and Ring
External power requirements	12V DC nominal, 500 mA
Batteries	Four 1.5V AA alkaline (not included)
Current consumption (battery)	350 mA typical
Battery life	10 hours typical, depending on battery type
	and use pattern
Dimensions	75.0 mm (2.95") W x 125.0 mm (4.92") H x
	32.0 mm (1.25") D
Net weight	300 g (10.5 oz) (without batteries)
Accessories included	Two flexible UHF antennas; 18" TA3F- to
	XLRM-type output cable; belt pouch
In the interest of standards development, A.T.U.S. offers full
details on its test methods to other industry
professionals on request.
Specifications are subject to change without notice.

top

bottom

Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224
Audio-Technica Limited, Old Lane, Leeds LS11 8AG England
©2010 Audio-Technica U.S., Inc. audio-technica.com	0001-0039-01